Bedienungsanleitung Honda HRX537 HMEA (Seite 13 von 22) (Englisch)

580909

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

ENGLISH

NOTICE

To prevent losing control of or damaging the mower, do not use the

drive system when going up or down a loading ramp.

To prevent damaging the drive system, do not engage the clutch

when the mower is rolling backwards.

1. Turn the fuel valve to the OFF position.

2. Use a suitable loading ramp. Adjust the loading ramp so that it is

inclined at an angle of less than 15°. If a loading ramp is not

available, two people should lift the mower on and off the transport

vehicle while keeping the mower level.

STORAGE

Proper storage is essential for keeping your lawn mower troublefree

and looking good. The following steps will help protect the mower

from rust and corrosion, and make the engine easier to start when you

use the lawn mower again.

Cleaning

1. Wash the lawn mower, including the underside of the mower deck.

Engine

Wash the engine by hand, and be careful to prevent water from

entering the air cleaner.

NOTICE

Using a garden hose or pressure washing equipment can force

water into the air cleaner. Water in the air cleaner will soak the

filters and can enter the carburetor or engine cylinder, causing

damage.

Water contacting a hot engine can cause damage. If the engine

has been running, allow it to cool for at least a half hour before

washing.

Mower Deck

If using a garden hose or pressure washing equipment to clean the

mower deck, be careful to avoid getting water into controls and

cables, or anywhere near the engine air cleaner or muffler

opening.

Before washing the underside of the mower deck, be sure the

throttle lever is in the STOP position and the fuel valve is in the

OFF position. Rest the mower on its right side, so the air cleaner

side is up. This will help to prevent fuel leakage and hard starting

due to carburetor flooding. Wear heavy gloves to protect your

hands from the blade(s).

Grass Bag

Remove the bag from the mower, and wash it with a garden hose

or pressure washing equipment. Allow the bag to dry completely

before storage.

2. After washing the lawn mower, wipe dry all accessible surfaces.

3. With the mower in an upright position, start the engine outdoors,

and let it run until it reaches normal operating temperature to

evaporate any water remaining on the engine.

4. Stop the engine and allow it to cool.

5. After the lawn mower is clean and dry, touch up any damaged

paint, and coat other areas that may rust with a light film of oil.

Charging the Battery (HMEA type)

To assure maximum reliability, the battery should be recharged (boost

charged) both before and after prolonged storage. A plug-in charger is

provided to recharge the battery (see page 19).

NOTICE

Do not charge the battery for more than 24 hours or the battery may

be damaged. Disconnect the battery charger from the battery before

storing the lawn mower.

Fuel

Gasoline will oxidize and deteriorate in storage. Old gasoline will

cause hard starting, and it leaves gum deposits that clog the fuel

system. If the gasoline in your mower deteriorates during storage, you

may need to have the carburetor and other fuel system components

serviced or replaced.

The length of time that gasoline can be left in your fuel tank and

carburetor without causing functional problems will vary with such

factors as gasoline blend, your storage temperatures, and whether

the fuel tank is partially or completely filled. The air in a partially filled

fuel tank promotes fuel deterioration. Very warm storage

temperatures accelerate fuel deterioration. Fuel deterioration

problems may occur within a few months, or even less if the gasoline

was not fresh when you filled the fuel tank.

To prevent fuel related problems:

1. Add gasoline stabilizer following the manufacturer’s instructions.

When adding a gasoline stabilizer, fill the fuel tank with fresh

gasoline. If only partially filled, air in the tank will promote fuel

deterioration during storage.

2. After adding a gasoline stabilizer, run the engine outdoors for

10 minutes to be sure that treated gasoline has replaced the

untreated gasoline in the fuel system.

3. Turn the fuel valve to the OFF

position.

4. Continue to run the engine until it

stops from the lack of fuel in the

carburetor fuel bowl. Running time

should be less than 3 minutes.

The warranty does not cover fuel

system damage or engine

performance problems resulting

from neglected storage

preparation.

Engine Oil

Change the engine oil (page 15).

Engine Cylinder

If the mower is to be stored for

more than 3 months, remove

the spark plug (page 16). Pour

5 ~ 10 cm³ of clean engine oil

into the cylinder [1]. Pull the

starter rope several times to

distribute the oil in the cylinder.

Reinstall the spark plug.

Pull the starter rope slowly

until resistance is felt, then

return the starter grip gently.

This will close the valves so

moisture cannot enter the

engine cylinder.

15°

OFF

[1]

HXE.book Page 13 Monday, August 6, 2007 10:44 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda HRX537 HMEA Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info