Bedienungsanleitung Honda UMK435E (Seite 7 von 18) (Englisch)

478015

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

7 EN

HOT START

The machine is considered to be "hot" if the engine has been

running for more than 5 minutes in the 10 minutes before starting

up.

The hot start procedure is the same as the cold start procedure

except that the choke [1] is not needed. (The lever must be left in

the low position).

NOTE:

Should you have difficultie store-start a hot engine, follows

this procedure:

1. Turn the engine to the OFF position (O).

2. Make sure that the choke lever is in OPEN position.

3. Keep the throttle control lever (throttle trigger) fully squeezed.

4. Pull the starter grip 3 to 5 times, and release the throttle control

lever (throttle trigger).

5. Start the engine referring to the procédures described above.

CAUTION:

• Be sure to turn the engine switch to the OFF position (O).

• If this operation is executed with the engine switch at the ON

position, the blade may rotate when the engine starts and a

personal injury may result.

STOPPING THE ENGINE

1. To stop the engine, press the Start/Stop button to engage the

Stop position (O) [2].

2. This step can also be taken to stop the machine in case of

emergency.

Note that the cutting attachment continues turning by inertia

after the engine has been stopped.

OPERATION

OPERATING POSITION

Once the machine has been started,

attach it to the harness as already

described in the section on preparation.

When handling the machine, take care to avoid striking any

objects with the cutting attachment and keep the cutting

attachment away from your body. Do not use the machine

unless it is attached to the harness.

Hold the brush cutter firmly by both grips as shown. Always keep

firm footing on both feet when working. Take appropriate breaks

and vary your working position.

CAUTION:

• When using the machine, always allow the engine to idle between

operations. If the machine is allowed to run at maximum speed

with no load (no resistance on the cutting attachment) for long

periods, the engine may be seriously damaged.

WITH NYLON LINE TYPE CUTTING

HEAD

This attachment is designed to complete the job

done with a lawnmower. It is especially handy

and efficient for cutting grass along walls or

fences, around trees or posts and on narrow or uneven surfaces

where a lawnmower cannot be used.

Make sure the line cutting blade is properly mounted on the

cutting attachment guard.

LINE LENGTH ADJUSTMENT

At maximum rotating speed, gently press the nylon line cutting head

on the ground. The line is automatically extended. Repeat this

operation until the optimal length is obtained.

When the engine is started and the cutting attachment starts

rotating, the excess line will automatically be cut by the line cutter

located on the guard.

CUTTING

The nylon line cuts grass cleanly without damaging tree bark and

avoiding the violent impacts that would occur between a rigid cutting

attachment and hard surfaces.

It is, however, recommended not to work too long in such areas in

order to avoid damaging fragile, immature plant, in particular, and to

avoid premature line wear.

Proceed in stages, when trimming, tilting the cutting attachment

slightly.

For larger areas, hold the cutting attachment horizontal and sway it

sideways from right to left and from left to right, alternately.

[1]

[2]

SAFETY

Read the

safety

instructions

SAFETY

A4 C11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda UMK435E Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda UMK435E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info