Bedienungsanleitung Honda UMK435E (Seite 8 von 18) (Englisch)

478015

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

8 EN

WITH 3-TOOTH AND 4-TOOTH

BLADE

CAUTION:

• Do not use a blade larger than

255 mm in diameter.

CUTTING

The 3-tooth and 4-tooth grass-

cutting blade is especially

suitable for clearing dense and

tangled weeds, bushes such as

brambles or wild shrubs with a

stem diameter of less than 2 cm.

To trim bushes, lower the cutting

attachment from above while

holding it horizontal so as to cut

the branches in small pieces.

It is dangerous to use grass-

cutting blades on very hard

wood and/or plants with a

large stem diameter. Kicking

of the cutting attachment is

difficult to control, and can seriously endanger the operator

and cause serious damage to the equipment.

WITH CIRCULAR SAW BLADE

Use of the circular saw blade is only authorized on UMK435E1

of type UEET.

CAUTION:

• Never use a saw blade with a diameter in excess of 200 mm. The

circular saw blade is intended to be used for cutting out shrubs,

bushes and small trees whose trunk does not exceed 6 cm in

diameter.

CUTTING

Some blade sectors [1] must

not be used as they will cause

the tool to rebound owing to

the direction of rotation.

Tools fitted on Honda

brushcutters rotate

counterclockwise. It NEVER

cut with the right half of the

blade. The part to be used is represented by the grey area.

For the best results, you must swing your equipment quickly

towards the branch or trunk to be cut. Do not proceed gradually as

engine speed could drop and lead to stalling.

Estimate the height of the items to be cut and where they might

fall.

Ensure that falling pieces will not cause bodily injuries to

persons or property damage.

Make sure the blade is not stuck in the trunk when it falls.

Always cut on the side opposite the fall.

MAINTENANCE

REPLACING THE LINE

1. Press the lugs [2] located on either side of

the head to open it.

2. Extract the reel and remove

the rest of the nylon line.

3. Prepare 3 metres of 2.7 mm

diameter line and fold it in

half, lengthwise.

4. Place the middle of the line in

the notch [5] in the reel and

coil the wire by turning in the

specified direction.

5. Secure the ends in the two

opposite notches [3] (leaving

an excess of 10 cm of line).

6. Reinstall the reel in its place

and feed the lines through

the two side holes [4].

7. Reinstall the cover.

CAUTION:

• Always use a line of the

diameter recommended in the

technical specifications.

• Poor results would be

obtained if the line diameter is

too large as this will result in

an excessive load on the

engine, so reducing its

performance.

Never replace the nylon line with a line of a different material,

such as steel wire.

To avoid severe personal injury, disconnect the spark plug cap

to prevent accidental starting.

Wear heavy gloves to prtect yur hands when replacing the

nylon head.

SHARPENING

3-TOOTH AND 4-TOOTH BLADES

Sharpening is essential to obtain good results. A slightly blunt

cutting attachment can be sharpened with a file.

A grinding wheel should be used if the wear is more severe.

CAUTION:

• In all cases, the cutting attachment must be kept correctly

balanced. If you do not have the required tools or if you think your

cutting attachment may not be properly balanced, contact your

authorized Honda dealer.

Remove the cutting attachment for sharpening and check that it is

not cracked, out of true or bent.

If it is, replace it with a new one.

SAFETY

C13

D2 D3

SAFETY

C13

D2 D3

[1]

C11B8

SAFETY

[3]

[2]

[4]

[5]

SAFETY

C13 D2 D3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda UMK435E Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda UMK435E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info