Bedienungsanleitung HP Aruba IAP-304 (Seite 5 von 11) (Englisch)

724190

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

Aruba 300 Series Wireless Access Point | Regulatory Compliance and Safety Information Guide 5

 DHCP Server with vendor-specific options

Verifying Pre-Installation Connectivity

Before installing access points in a network environment, make sure that they are able to locate and connect to the controller

after power on.

Specifically, you must verify the following conditions:

 When connected to the network, each access point is assigned a valid IP address

 Access points are able to locate the controller

Refer to the ArubaOS Quick Start Guide for instructions on locating and connecting to the controller.

Identifying Specific Installation Locations

You can mount the 300 Series access point on the ceiling or a wall. Use the access point placement map generated by Aruba’s

RF Plan software application to determine the proper installation location(s). Each location should be as close as possible to

the center of the intended coverage area and should be free from obstructions or obvious sources of interference. These RF

absorbers/reflectors/interference sources will impact RF propagation and should have been accounted for during the planning

phase and adjusted for in RF plan.

Identifying Known RF Absorbers, Reflectors and Interference Sources

Identifying known RF absorbers, reflectors, and interference sources while in the field during the installation phase is critical.

Make sure that these sources are taken into consideration when you attach an access point to its fixed location. Examples of

sources that degrade RF performance include:

 Cement and brick

 Objects that contain water

 Metal

 Microwave ovens

 Wireless phones and headsets

Installing the Access Point

The 300 Series access points ship with a ceiling rail adapter to attach to a 9/16” or 15/16” ceiling rail. Additional ceiling or wall

mount kits are sold separately as accessories.

1. Pull the necessary cables through a prepared hole in the ceiling tile near where the access point will be placed.

2. Place the adapter against the back of the access point with the adapter at an angle of approximately 30 degrees to the tabs

(see Figure 4).

3. Twist the adapter clockwise until it snaps into place in the tabs (see Figure 4).

Aruba Networks, Inc., in compliance with governmental requirements, has designed the 300 Series access points so that only

authorized network administrators can change the settings. For more information about access point configuration, refer to

the ArubaOS Quick Start Guide /Aruba Instant Quick Start Guide and ArubaOS User Guide/Aruba Instant User Guide.

The instructions for this section are applicable to the AP-304 and AP-305 only.

Service to all Aruba Networks products should be performed by an AMCP certified technician or similar.

The installer is responsible for securing the access point onto the ceiling tile rail in accordance with the steps below. Failure

to properly install this product may result in physical injury and/or damage to property.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

HP Aruba IAP-304 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info