10 English
The infrared motion transmitter can
detect movement at a maximum
distance of up to 6 meters away.
The opening angle measures approx.
35° to 40°.
Please note the following when set
-
ting up the infrared motion transmit-
ter:
1. The infrared reception sensor
must be free and clear.
2. The maximum infrared recognition
range must be observed.
Switching on the infrared motion
transmitter
Use the slider switch on the right-
hand side of the device to switch the
transmitter on.
There are two ways to activate the
infrared reception sensor:
1. Switch on the Alarm ON/OFF
switch on the bottom of the trans-
mitter (switch pressed in = IR
motion transmitter is activated).
2. Use an external ON/OFF switch.
Once the transmitter has been
activated, the infrared reception
sensor takes about 30 seconds to
switch on to give you time to leave
the alarm area. If a person or animal
comes within the recognition range
of the infrared motion sensor, an
alarm signal will sound.
are picked up without errors. This
process also makes it possible to set
10 different radio channels.
When supplied from the factory, all
Infrared motion transmitters are set
to channel 0. It is only necessary to
set units to other channels if you
have several different users opera-
ting units in the same building.
Set the channel you want by adju-
sting the channel selector switch on
the left-hand side of the unit to the
required channel number. Use a
small screwdriver to adjust this
switch.
All transmitters and receivers must
be set to the same channel.
4. Installation of the infrared
motion transmitter
➡
Fig. setting the correct radio channel
max. 6 m
