Message Cause Action
Zone generator prob-
lem
FlexiFence problem
The battery of the FlexiFence accessory is
low. The FlexiFence accessory does not op-
erate when the battery is empty. The product
can cut in the stay-out zone if you start the
product before you charge the FlexiFence
accessory.
Park the product and charge the FlexiFence
accessory before you start the product.
The temperature in the FlexiFence accessory
is a higher than the maximum limit and is set
to off.
Put the product in an area with protection
from the sun. Let the temperature of the
FlexiFence accessory decrease before you
start the product.
Difficult finding home
The product has followed the boundary wire
several laps but has not found the charging
station.
Examine the settings of the corridor width for
the boundary wire.
6.3 Information messages
The information messages in the table below are shown in the display of the product. Speak to your Husqvarna
representative if the same message shows frequently.
Message Cause Action
Low battery
The product cannot find the charging station. Change the position of the guide wire. Refer
to
To install the guide wire on page 19
.
The battery is at the end of its life cycle. Replace the battery. Refer to
Battery on
page 35
.
The antenna of the charging station is defec-
tive.
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
Indicator
lamp in the charging station on page 41
.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Clean the charging plates and contact plates.
If the problem stays speak to your Husqvar-
na service.
Settings restored
A
Reset all user settings
has been done. Usual operation of the product.
Guide 1 not found
The guide wire is not connected to the charg-
ing station.
Connect the guide wire to the charging sta-
tion. Refer to
To install the guide wire on
page 19
.
Damage in the guide wire. Replace the damaged section with new
guide wire.
The guide wire is not connected to the boun-
dary loop.
Connect the guide wire correctly to the boun-
dary loop. Refer to
To install the boundary
wire on page 18
.
Guide calibration
failed
The product has not calibrated the guide wire
because of an error.
Install the guide wire correctly. Refer to
To
install the guide wire on page 19
.
Guide calibration
done
The product has calibrated the guide wire. Usual operation of the product.
Connection changed
New loop signal changed. Usual operation of the product.
40 - Troubleshooting 1462 - 007 - 14.03.2022
