6 Troubleshooting
6.1 Introduction - troubleshooting
In this chapter, a number of messages are listed which may be shown in Automower
®
Connect and
Automower
®
Access if there is a malfunction. There is a proposal action to the cause and steps to take
for each message. This chapter also presents some symptoms that can guide you if the product does
not work as expected. More suggestions for steps to take in the event of malfunction or symptoms can
be found on www.husqvarna.com.
6.2 Error icons in the Automower
®
Access display
If an error icon is shown in the Automower
®
Access display, push the STOP button to confirm the error
and return to the main menu. More information about the error can be found in Automower
®
Connect.
Error icon Description Action
The product has stopped because of
an unexpected situation.
Examine if the cause of the problem is
obvious. For example, if the product is
not in the work area or if the product is
in top of an object (stone, branch, etc).
Restart the operation of the product.
The product has stopped because of
an unexpected behavior from the wheel
motors.
Examine the drive wheels and remove
grass or other objects. Restart the op-
eration of the product. Contact your lo-
cal Husqvarna representative if the
problem is frequent.
The product has stopped because the
loop signal is missing.
Refer to the error message "No loop
signal" in
Fault messages on page 47
.
46 - Troubleshooting 1404 - 001 -