confirmed in Automower
®
Access display on the product. Contact your local Husqvarna representative
if the same message appears often. For more information, refer to
Messages on page 36
.
Message Cause Action
No loop signal
The power supply or the voltage cable
are not connected.
Examine the LED status on the charg-
ing station. If the LED is not lit, it indi-
cates that there is no power. Examine
the wall socket connection and whether
an earth-fault breaker has tripped.
Make sure that the low voltage cable is
connected to the charging station.
The power supply or low voltage cable
are damaged.
Replace the power supply or low volt-
age cable.
The boundary wire is not connected to
the charging station.
Make sure that the boundary wire con-
nectors are fitted properly to the charg-
ing station. Replace connectors if dam-
aged. Refer to
To install the boundary
wire on page 27
.
The boundary wire is broken. Check the signal given by the LED on
the charging station. If the LED indi-
cates break in the boundary wire, find
out where the break is. Replace the
damaged section of the loop with a new
loop wire and splice using an original
coupler. Refer to
Find breaks in the
loop wire on page 57
.
ECO mode
is activated and the prod-
uct has attempted to start outside the
charging station.
Put the product in the charging station.
Start the product and close the hatch.
The pairing between the product and
the charging station is lost.
Put the product in the charging station
and generate a new loop signal. Refer
to
To create a New loop signal on page
35
.
The boundary wire is crossed on its
way to and from an island.
Make sure that the boundary wire is in-
stalled correctly. Refer to
To install the
boundary wire on page 27
.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles.
Move the boundary wire and/or make
more islands in the work area to in-
crease the signal strength.
Wheel motor
blocked
Grass or other object has wrapped
around the drive wheel.
Examine the drive wheel and remove
the grass or other object.
Wheel drive prob-
lem
48 - Troubleshooting 1404 - 001 -
