Bedienungsanleitung Husqvarna Automower 450X NERA - 2023 (Seite 35 von 48) (Englisch)

819081

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Message Cause Action

Temperature restric-

tion

The product does not operate if the battery

temperature is too high or too low.

The product starts to operate again when the

temperature is between the set limits and the

schedule settings let the product to operate.

Make sure that the charging station is put in

an area with protection from the sun.

Charging current too

high

The battery charges with a too high current.

The power supply unit is incorrect or dam-

aged.

Make sure that the power supply unit and

charging station are not damaged. Make

sure the that you use the correct power sup-

ply unit and charging station. Restart the

product. If the problem stays, speak to your

authorized service center.

Charging system

problem

There is corrosion or dirt on the charging

plates and contact plates.

Restart the product. Clean the charging

plates on the product and the contact plates

on the charging station.

Temporary electronic or firmware problem in

the product.

Restart the product. If the problem stays,

speak to your approved servicing dealer.

No power in charging

station

The power supply unit is incorrect or dam-

aged.

Examine the power supply unit. Replace if

necessary.

Power failure. Find and correct the cause of the power fail-

ure.

The product cannot charge because there is

no contact between the contact plates and

the charging plates.

Make sure that the charging plates and the

contact plates are in contact. Clean the con-

tact plates and charging plates.

Charging station

blocked

The product cannot go into the charging sta-

tion because it is blocked or the baseplate of

the charging station is tilted or bent.

Examine why the product cannot go into the

charging station. Remove any objects and

make sure that the baseplate of the charging

station is level.

The product cannot go into the charging sta-

tion because it is blocked or the baseplate of

the charging station is tilted or bent.

Examine why the product cannot go into the

charging station. Remove any objects and

make sure that the baseplate of the charging

station is level.

Stuck in charging sta-

tion

The product cannot leave the charging sta-

tion because it is blocked or it slips on the

baseplate of the charging station.

Examine why the product cannot leave the

charging station. Remove any objects and

clean the baseplate of the charging station.

FlexiFence problem

The battery of the FlexiFence accessory is

low. The FlexiFence accessory does not op-

erate when the battery is empty. The product

can cut in the stay-out zone if you start the

product before you charge the FlexiFence

accessory.

Park the product and charge the FlexiFence

accessory before you start the product.

The temperature in the FlexiFence accessory

is a higher than the maximum limit and is set

to off.

Put the product in an area with protection

from the sun. Let the temperature of the

FlexiFence accessory decrease before you

start the product.

2071 - 001 - 29.03.2023 Troubleshooting - 35

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna Automower 450X NERA - 2023 Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Husqvarna Automower 450X NERA - 2023

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info