7.3 Information and warning messages
The information messages in the table below are shown in the
Messages
menu in the Husqvarna Fleet Services™
app. Speak to your approved servicing dealer if the same message shows frequently.
Message Cause Action
Cutting system imbalance
The product senses vibrations in the cut-
ting disc.
Examine the blades and screws for dam-
ages and wear. Make sure that all blades
are correctly installed and that there is
only one blade attached in each position
on the blade disc.
Connectivity problem
Problem with the Automower® Connect
module.
Restart the product. Disable Automower®
Connect in the app and enable it again.
Wait 1 hour and try again. If the problem
stays, speak to your local approved serv-
icing dealer.
Wrong PIN code
An incorrect PIN code was entered. 5
tries are permitted, and the product is
then blocked for a period of time.
Enter the correct PIN code. If the PIN
code is incorrect, use the web address in
the app to send the PIN code to your reg-
istered e-mail address. If you have not
registered the e-mail address, speak to
your approved servicing dealer.
GPS navigation problem
Temporary electronic or firmware related
problem in the product.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
Ultrasonic problem
The ultrasonic sensor is dirty or blocked. Clean the ultrasonic sensor.
Temporary electronic or firmware related
problem in the product.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
7.4 LED indicator lamps on the charging station
For a fully functional installation, the indicator lamps in the charging station must show a solid or flashing green light. If
another color shows, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, speak to your approved servicing dealer.
Light Status
Green solid light Good signals.
Green flashing light The signals are good and
ECO mode
is activated. Refer to
ECO mode on page 25
.
Red flashing light Interruption in the charging station’s antenna. Speak to your approved servicing
dealer.
Red solid light Fault in the circuit board or incorrect power supply in the charging station. The
fault must be correct by an authorized service technician. Speak to your approved
servicing dealer.
1691 - 006 - 09.01.2023 Troubleshooting - 43
