Bedienungsanleitung Husqvarna LC 551iV (Seite 22 von 604) (Alle Sprachen)

733939

Zoom out

Zoom in

Vorherige Seite

1/604

Nächste Seite

To use the drive on the wheels (LC

551iV)

• Pull the drive bail in the direction of the handlebar to

start the drive. (Fig. 57)

• Push + and - on the control panel to set the drive

speed in 4 steps. (Fig. 58)

• Release the drive bail to disengage the drive, for

example when you go near an obstacle.

To use the SavE function

The product has a battery saving function (SavE) that

gives longer operation time.

1. Push the SavE button (A) to start the function. The

SavE symbol (B) on the display comes on.

2. Push the SavE button again to stop the function. The

SavE symbol (B) on the display goes out. (Fig. 59)

The SavE function stops automatically if the ground

conditions make it necessary to have a higher output.

The SavE function starts automatically again when the

ground conditions let it.

PowerBoost function

When the product cuts long or wet grass, the motor

automatically increases rpm. To save battery time, the

motor goes back to standard mode automatically when

the PowerBoost function is not necessary.

To stop the product

The product stops automatically if you do not operate it

for 3 minutes.

1. Release the motor brake handle to stop the motor.

(Fig. 21)

2. Push the ON/OFF button on the control panel. All

LED lights and symbols on the display go out. (Fig.

60)

3. Remove the safety key from the safety lock and put

it in the safety key holder.

To get a good result

• Always use a sharp blade. A blunt blade gives an

irregular result and the cut surface of the grass

becomes yellow. A sharp blade also uses less

energy than a blunt blade.

• Do not cut more than ⅓ of the length of the grass.

Cut first with the cutting height set high. Examine the

result and lower the cutting height to an applicable

level. If the grass is very long, drive slowly and cut 2

times if necessary.

• Cut in different directions each time to prevent

stripes in the lawn.

To cut grass without a grass catcher or

mulch plug attached (LC 551iV)

1. Lift up the rear cover and remove the grass catcher.

2. If a mulch plug and a mulch blade are attached,

remove them.

3. Close the rear cover before you operate the product.

When you operate the product, the cut grass discharges

below the rear cover.

Maintenance

Introduction

WARNING: Before you do maintenance, you

must read and understand the safety

chapter.

For all servicing and repair work on the product, special

training is necessary. We guarantee the availability of

professional repairs and servicing. If your dealer is not a

service agent, speak to them for information about the

nearest service agent.

Maintenance schedule

The maintenance intervals are calculated from daily use

of the product. The intervals change if the product is not

used daily.

For maintenance identified with *, refer to

Safety

instructions for operation on page 15

Each use Monthly

Each

season

Do a general inspection X

Clean the transmission covers. Make sure that the motor does not have grass on

Do a check of the start inhibitor * X

Make sure that the safety devices on the product are not defective * X

22 1336 - 003 - 17.12.2019

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna LC 551iV Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info