Bedienungsanleitung Husqvarna Z560X (Seite 17 von 280) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

733969

Zoom out

Zoom in

Vorherige Seite

1/280

Nächste Seite

Read the Safety section and following pages, if

you are unfamiliar with the machine.

Training

Due to unique steering capabilities, zero turn

mowers are far more maneuverable than typical

riding mowers.

Review this section fully before trying to move the

mower under its own power. When rst operating

the mower or until becoming comfortable with

controls, use a reduced throttle speed and

reduced ground speed. DO NOT move control

levers to the furthest forward or reverse positions

during initial operation.

First time users must become familiar with the

mower’s movement on a hard surface, such as

concrete or blacktop BEFORE trying to operate

on turf. Until the operator becomes comfortable

with the mower controls and zero turn, overly

aggressive maneuvers can damage turf.

Steering

To move forward and rearward

The direction and speed of the mower’s

movements are eected by the movement of

the control lever(s) on each side of mower. The

left lever controls the left wheel. The right lever

controls the right wheel.

First time users must push the mower (see

Moving Machine By Hand in the Operation

section) to an open, at area without other

persons, vehicles or obstacles nearby. To move

the unit under its own power, the operator must

sit in the seat and start the engine (see Before

Starting in the Operation section). Adjust the

engine speed to idle but do not engage the

blades. Pull control levers inward. As long as the

control levers have not been moved forward or

rearwards, the mower will not move.

Slowly move the two control levers forward

slightly. This will let the mower start moving

forward in a straight line. Pull the control levers

back to the neutral position and stop the mower

from moving.

Pull back slightly on control levers, allowing the

mower to move rearwards. Push the control

levers forward to the neutral position to stop the

mower from moving.

To turn to the right

While moving in a forward direction, pull the right

lever back towards the neutral position while

maintaining the position of the left lever, this will

slow the rotation of the right wheel and cause the

machine to turn in that direction.

To turn to the left

While moving in a forward direction pull the left

lever back towards the neutral position while

maintaining the position of the right lever, this will

slow the rotation of the left wheel and cause the

machine to turn in that direction.

To zero turn

While moving in a forward direction, rst pull the

two control levers back until the mower stops or

slows dramatically.

Then by alternating one lever slightly to the

forward position and the other in the reverse

position, complete the turn.

WARNING! Make sure the work area is

free of stones and other objects that could be

thrown by the rotating blades.

Roll Bar

Operate the unit with the roll bar in the raised and

locked position and use the seat belt. There is

no rollover protection when the roll bar is down.

If it is necessary to lower roll bar, do not wear the

seat belt. Raise the roll bar as soon as clearance

permits.

WARNING! The seat belt must be used

when the roll bar is in upright position.

Before Starting

WARNING! Make sure the work area is

free from of stones and other objects that could

be thrown by the rotating blades.

1. Read the sections on Safety and Controls

before starting the machine.

2. Perform the daily maintenance before

starting (see Maintenance Schedule in the

Maintenance section).

3. Check that there is sucient fuel in the fuel

tank.

4. Adjust the seat to the desired position.

The following conditions must be fullled before

the engine can be started:

• The blade switch must be pressed down into

the disengaged position.

• The two steering / park brake controls must be

in the locked (outer) position.

Starting the Engine

1. Sit on the seat.

2. Raise the mower deck to the transport

position by pushing the lift pedal forward.

OPERATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna Z560X Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info