Bedienungsanleitung Husqvarna Z560X (Seite 18 von 280) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

733969

Zoom out

Zoom in

Vorherige Seite

1/280

Nächste Seite

3. Disengage the mower blades by pressing the

blade switch down.

4. Move the steering / park brake controls to the

locked (outer) position.

5. Move throttle control to the middle position. If

the engine is cold, pull the choke control up.

6. Set the fuel tank valve to the desired tank.

7. Set the deck height pin in the desired position.

8. Press in and turn the ignition key to the start

position.

IMPORTANT INFORMATION Do not run the

starter for more than ve seconds each time. If

the engine does not start, wait approximately

ten seconds before retrying.

9. When the engine starts, immediately release

the ignition key back to the run position.

Slowly push in the choke control knob, if it

was used to start a cold engine.

10. Set the engine speed with the throttle. Allow

the engine to run at a moderate speed,

approximately mid throttle, for a short time

before use. USE FULL THROTTLE WHEN

MOWING (no choke).

Running

1. Release the park brake by pulling the steering

/ park brake controls in to the neutral position

at the same time.

NOTE: The mower is equipped with an

operator presence system. If the operator

tries to leave the seat with the engine running,

without rst engaging the park brake, the

engine will shut o.

2. Release deck height control by pushing the

pedal forward to lower the deck to selected

setting.

3. Move throttle control to full throttle.

4. Engage the mower deck by pulling the blade

switch up.

WARNING! Make sure that no one is

near mower when engaging blade switch.

5. Pull control levers inward and slowly move

the two control levers slightly forward to move

forward in a straight line.

Stopping the Engine

1. Move the throttle to the minimum position

(tortoise symbol).

2. Move the steering / park brake controls at the

same time out to the park brake position.

3. Release the mower deck by pressing the

blade switch down.

4. Raise the mower deck by pressing the foot

pedals forward to the transport position.

If the engine has been worked hard, allow it to

idle at least sixty seconds to attain a normal

operating temperature before stopping. To

prevent fouling the spark plugs, avoid idling

the engine for longer periods.

5. Turn the ignition key to the stop position and

remove the key. Always remove the key when

leaving the mower to prevent unauthorized

use.

IMPORTANT INFORMATION When stopping

and leaving the machine, the two steering /

park brake controls must be moved out to the

locked position at the same time.

IMPORTANT INFORMATION Leaving the

ignition switch in a position other than OFF will

cause the battery to be discharged.

Operating on Hills

Read the Safety Instructions Driving on Slopes

in the Safety section.

• Use the slowest speed possible before starting

up or down hills.

• If stopping is fully necessary, pull steering / park

brake controls into the neutral position and push

outward to engage the park brake.

• Pull the steering / park brake controls back to

the center of the mower and push forward to

regain forward movement.

OPERATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna Z560X Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info