733969
25
Zoom out
Zoom in
Vorherige Seite
1/280
Nächste Seite
Tire Pressures
All tires must be at 15 psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION DO NOT add
a tire liner or foam ll material to the rear tires.
Excessive loads created by foam lled tires will
cause premature failures.
Only use O.E.M. specied tires.
Deck Lift Spring
When mowing 5.1 cm or lower, it may be
necessary to adjust the deck lift springs. Access
the springs by tilting the seat forward. Loosen the
nut to adjust the spring tension.
Park Brake
WARNING! Faulty adjustment will result
in reduced braking and can cause an accident.
Visually check that no damage is found on the
steering control levers, links or switches belonging
to the park brake. Do a standstill test and check
that there is sucient braking action.
1. Make equal adjustments on the two park
brake controls. To make adjustments, remove
the rivet pins from the boot and slide the boot
up.
2. If the park brake position does not pass the
standstill test, or has needed maintenance,
it may need adjustment. The spring should
measure a compressed length of 12.7 mm
shorter than the free length. Tighten the nuts
holding the brake spring if necessary.
3. To change the park brake action, tighten
the pivot bolt until the desired braking feel is
correct.
Neutral Adjustment
Perform the adjustment with the machine parked
on level ground and the park brake engaged.
1. Raise the rear wheels of the machine and
support it with jack stands.
2. Start the engine. If the either wheel turns while
the machine's park brake is engaged, the
neutral linkage for the corresponding wheel
must be adjusted.
3. To access the control rod linkage, unlatch and
rotate the seat forward.
4. Remove and retain the pin from the front
coupler.
5. Turn the hex nut by hand in either direction
until the wheel stops turning.
6. Turn the hex again, counting the number of
turns with the at surfaces of the nut. Stop
turning when the wheel spins in the opposite
direction.
7. Turn the nut back, one half of the amount of
turns counted in Step 6.
8. Repeat with the opposite wheel if necessary.
25
MAINTENANCE
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Husqvarna Z560X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info