Bedienungsanleitung Hwam 3650 (Seite 10 von 60) (Englisch)

571903

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Drawing A

HWAM 3610/3630/3650

Min. distances:

HWAM 3620/3640/3660

Min. distances:

1. Recommendedforbrickwall,back,cm 10 10

2. Recommendedforbrickwall,side,cm 15 10

1. For inﬂammable wall, back, cm 10 10

2. For inﬂammable wall, side,cm 40 40

1. To inﬂammable wall,corner installation,cm 35* 20*

3. Distance to furnishings in front, cm 90 90

*All dimensions in connection with corner installation are only recommendations. Contact your chimney

sweep for a clariﬁcation.

Please be aware that not all glass parts are heat-resistant. For this reason, a glass wall should sometimes

be treated as a ﬂammable wall, in which case we ask you to contact your local chimney sweep or glass

producer to hear at what distance the stove should be kept from glass.

Remember to pay attention to any regulations concerning the required distance between

the wall and smoke pipe.

The distance to a brick wall is set to faciliate the servicing of the HWAM Autopilot IHS

Requirements for chimney and smoke pipe

The chimney must be of a sufﬁcient height to enable an adequate draft and to prevent smoke problems. The

stove requires a draft of at least 12 Pa.

The chimney must have a minimum opening equivalent to Ø 15 cm. The chimney opening should always

be at least the size of the outlet socket of the stove. The chimney must have an easily accessible soot door.

Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer for

more information.

Fitting the loose parts

Before the stove is installed, you must ensure that all loose parts are ﬁtted correctly. Make sure that the

chimney is tight and that no false draft is caused around neither the cover plate, in connection with a

coveredsmokeoutlet,northecleanoutdoorandpipeconnections.Pleasenotethatbentand/orhori-

zontal smoke pipes will reduce the effect of the chimney draft.

Vertical cross-section of the stoves (Drawing B)

B1:HWAM3610,HWAM3620

B2:HWAM3630,HWAM3640

B3:HWAM3650,HWAM3660

1. Smoke shelf. Must be placed on the steel rail and the holder at the front in the middle.

2. The bafﬂe plate is suspended on three hooks beneath the top plate. One of the hooks has an additional

ﬂap that is bent upwards as protection during transport. This ﬂap should be removed with the help

of a screwdriver before installation.

3. The rear smoke outlet has been closed at the factory by screwing a plate over it and it is therefore

hidden behind the rear plate.

4. Removablerearplate.Thismustalwaysbemountedifthestoveisplacednexttoacombustiblewall.

5. Loose heat shield. This must always be mounted if the stove is placed next to a combustible wall.

6. Loose heat shield beneath the ash pan. Can be used as a lid when the ash pan is removed for emptying.

Connection to chimney

All the stoves have both rear and top smoke outlet.

that can be connected to an approved steel chimney on top or directly out at the rear to a chimney.

Make sure that the chimney is tight and that no false draft is caused around neither the cover plate, in

connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that

bentand/orhorizontalsmokepipeswillreducetheeffectofthechimneydraft.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 3650 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 3650

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info