Bedienungsanleitung Hwam 3650 (Seite 12 von 60) (Englisch)

571903

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

main menu. If you do not press the button again, the remote control automatically leaves the menu

and returns to the start display.

4. Go through the self-test of the HWAM Autopilot IHS

The self-test of the electronic control is carried out before lighting the ﬁrst ﬁre in the stove (the

factory will see to this). The self-test can only be done when the wood-burning stove is cold and in

standby mode (no signal in the status line

). Make sure that the display is

not active, i.e. there should be no light in the display (

). If there is light in the

display before you hold down the button for a while, you will instead prepare the wood-burning stove

for lighting (the matchbox will appear in the display) and no self-test can be carried out.

Press the remote control button for approx. 5 seconds in order to enter the menu. Press the button

until the cursor reaches “Self-test”. Wait a few seconds till the remote control enters the “Self-test”

menu. Press the button till the cursor reaches “Engage”. A few seconds later the self-test begins.

By going through a self-test you ensure that all basic operations function correctly.

 Aself-testconsistsoffourtesttypes:

 •Asoftwaretest

 •Atestofthetemperaturesensorandcalibration

 •Atestofthelambdasensorandcalibration

 •Atestofthethreemotorvalvesandcalibration

The remote control will respond with the text ”Pass” if everything is OK or ”Failed” if there is a

problem. The remote control will also respond with the text "Failed" if you, prior to self-test with the

remote control, have prepared the wood-burning stove for lighting up a ﬁre (made the match box

appear on the display). If the electric power is cut and switched on again, the programme will return

to standby and the self-test can be carried out. If the remote control responds with the text "Not

completed", the self-test could not be carried out, either because the wood-burning stove has not

cooled off or because it is not in standby mode.

5. The remote control must be placed in the same room as the wood-burning stove and in a location

where it is neither exposed to direct heat radiation from the stove nor to direct sunlight. The reason

is that the remote control functions as a thermometer. The room temperature is transmitted wirelessly

to the stove’s electronic control to support the intelligent regulation of the combustion. The remote

control stand can be mounted on the wall.

Chimney

The chimney is the “engine” of the stove and it is crucial for the functioning of the woodburning stove.

The chimney draft provides a partial vacuum in the stove. The partial vacuum removes the smoke from

the stove, sucks air through the damper to the so-called pane ﬂush mechanism, which keeps the window

pane soot free, and sucks air into the combustion via the HWAM Autopilot IHS

The chimney draft is created by the differences in temperature inside and outside the chimney. The higher

the temperature within the chimney, the greater the draft (a brick chimney takes longer to warm up than

a steel chimney). On days where the weather and wind conditions create insufﬁcient draught inside the

chimney, it is even more important to warm up the chimney as quickly as possible. The trick is to quickly

get some ﬂames going. Split the wood into extra ﬁne pieces, use an extra ﬁrelighter, etc.

If the stove has not been used for a longer period, it is important to check that the chimney pipe is not

blocked. It is possible to connect several devices to the same chimney. However, it is important to ﬁrst

check the applicable rules.

Even a good chimney can function badly if it is not used correctly. Similarly, a bad chimney may function

well if used correctly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 3650 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 3650

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info