Bedienungsanleitung Hyundai HHA282104 (Seite 7 von 16) (Deutsch, Englisch, Holländisch, Französisch)

802226

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Measuring procedure:

After the cuff has been appropriately positioned.the measurement can

begin:

1) Press the START/STOP button, all symbols appear on the display,

you can hear 2 short beep after O ash for 2

seconds, then the pump begins to inate the cuff,

the rising pressure in the cuff Is shown on the

display.

2) After the suitable pressure has been reached, the

pump stops and the pressure gradually falls T he

cuff pressure 1s displayed In case that the ination

is not sufcient the device automatically re-Inates

to a higher pressure

3) When the device detects the signal, the heart

symbol on the display starts to ash, you can hear

the beep for every heartbeat once the heartbeat

signal 1s detected

4) When the measurement has been completed,

you can hear a long beep, in the meantime , the

systolic. diastolic and pulse rate will appear on the

display.

5) The measurement readings remain on the display

until you switch off the device. If no button is pressed for a period of

3 minutes, the device switches off itself in order to save the power.

Note:

It will read in kPa as unit when you choose kPa. The symbol will be

displayed along with the reading if the irregular heartbeat is detected

during the measurement.

Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement for any

reason (eg. the patient feels unwell) the START/STOP button can be

pressed at any time. The device immediately decrease the cuff

pressure automatically.

Memory-recall of measurements

This blood pressure monitor automatically stores 1 * 199 sets

measurements value, the oldest record will be replaced by the latest

measurement value when more than 199 sets each user.

Read memory record

Press the button when power off, the last measurement value will be

shown, as well as subsequent measurements can be display one after

the other by pressing the button each time.

Memory -clear of measurements

If you are sure that you want to permanently remove all stored

memories. press the button until it is shown CL, after this press

button then all the records will be cleared.

About blood pressure

Blood pressure is the pressure exerted the arteries. The systolic blood

pressure value represents the blood pressure produced by contraction

of the heart muscle. The diastolic blood pressure value represents the

blood pressure produced by relaxation of the heart muscle.

• According to the blood pressure classication by the WHO/ISH.

• SYS lower than 100mmHg(13. 3kPa) is considered as hypotension.

• Blood pressure type 120 130 140 160 180

ERROR INDICATORS

• The following symbol will appear on the display when measuring

abnormal.

TROUBLESHOOTING

CARE FOR THE MAIN UNIT AND BLOOD PRESSURE MONITOR CUFF

• Keep the unit in the storage case when no use.

• Clean the unit with soft dry cloth. Do not use any abrasive or volatile

cleaners.

• Never immerse the unit or any component in water.

• Make sure the monitor is off prior to cleaning, a mixture of distilled

water and 10 percent bleach could be used.

• Using a spray bottle, moisten a soft cloth towel with the bleach or

detergent mix until it is fully saturated. Squeeze any excess moisture

from the cloth to avoid any dripping or potential oversaturation of the

cuff.

• Wipe all surfaces of the blood pressure monitor cuff thoroughly,

making sure to clean the inside and outside of the cuff. Be cautious

not to get any moisture in the main unit.

• Using a dry cloth, gently wipe away any excess moisture that may

remain on the blood pressure cuff. Lay the cuff at in an unrolled

position and allow the cuff to air dry.

MAINTENANCE

• Do not clean the body and cuff With naphtha, thinner or gasoline etc.

• Do not wet the cuff or attempt to clean the cuff with water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hyundai HHA282104 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info