55
Dishwasher installation steps
1. Install the furniture door to the outer door of the dishwasher using the brackets provided. Refer to the
template for positioning of the brackets.
2. Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to tighten the
left and right door springs. Failure to do this could cause damage to your dishwasher (illustration 2).
3. Connect the inlet hose to the cold water supply.
4. Connect the drain hose. Refer to diagram (Fig. 6).
5. Connect the power cord.
6. Affix the condensation strip under the work surface of cabinet. Please ensure the condensation strip is
flush with edge of work surface.
7. Place the dishwasher into position.
8. Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher by turning the
screws on the left and right hand side of the cabinet (Illustration 5A). To adjust the front feet, use a
wrench and turn the front feet until the dishwasher is level (Illustration 5B).
9. The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface-secure to the work surface by using two woodscrews ensuring the
dishwasher weight is not being hit by the surface (Illustration 6).
B. Marble or granite work top-secure the bracket to the side panel of the dishwasher and secure the
dishwasher to the furniture housing. Put the rubber cap over the screw (Illustration 7).
Figure 7
Screw
Cone gear
Screw
Rubber cover
Furniture door
Condensation strip
