Bedienungsanleitung Indesit dv 640 a ix (Seite 21 von 68) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

124778

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Cleaning and Special Maintenance

The filter assembly

If you want consistent good

results from your dishwasher,

you need to clean the filter

assembly.

The food particles are

removed from the wash

water, allowing it to be

recirculated during the cycle,

filtered perfectly. For this

reason, it is a good idea to

remove the larger food

particles trapped inside the

semi-circular filter A and cup

“C”after each wash; to

remove the filter assembly, pull the cup handle upwards. All

you need to do is rinse them under running water.

The entire filter assembly should be cleaned thoroughly once a

month: semi-circular filter A + cup C + cylindrical filter B+

microfilter D.

To remove filter “B”, turn it anti-clockwise. Use a small non-

metallic brush for cleaning.

Reassemble the filter parts (as shown in the figure) and reinsert

the whole assembly into the dishwasher. Position it into its

housing and press downwards.

The dishwasher is not to be used

without filters. Improper replacement of the filters may reduce

the efficiency of the wash and even damage your dishwasher.

Cleaning the Sprayer Arms

It may happen that food particles become encrusted on the

sprayer arms and block the holes. Check the sprayer arms

periodically and clean them when needed (see “Close-up

View [interior]”, letters F-I).

Troubleshooting

It may occur that the dishwasher does not function or does not

function properly. Before calling for assistance, let us see what

can be done first: have you forgot to press one of the buttons

or to perform an essential operation?

The Dishwasher Does Not Start

Have you checked whether:

- the plug is pushed into the socket correctly;

- the power is on in the house;

- the door is closed properly;

- the ON-OFF switch is on "ON";

- the water supply is turned on.

The Dishwasher Does Not Load Water

Have you checked whether:

- the water is turned on and the hose is connected properly;

- the water supply to the house is on and has sufficient

pressure;

- the water supply hose is crimped or bent;

- the filter for the water supply hose is clogged.

The Dishes Are Not Clean

- Have you put the right amount of detergent into the

dispenser?

- Is the wash cycle suitable for the dishes you have placed

inside the appliance?

- Are the filter and microfilter clean?

- Can the sprayer arms turn freely?

The Dishwasher Does Not Drain

Have you checked whether:

- the drain hose is crimped or bent.

Lime Deposits or a White Film Form on the Dishes

Have you checked whether:

- the lid to the salt container is closed properly;

- the rinse aid dosage is correct.

Error messages.

Your dishwasher is equipped with a safety system which is able to

detect any operating anomalies. These anomalies are reported by

one or two wash cycle indicator lights "G" flashing rapidly.

Take a note of which lights are flashing, turn the appliance off and

call for technical assistance.

Tap off alarm

If you have forgotten to turn the water tap on, your appliance will

remind you of this by sounding a few short beeps for a few minutes.

Turn the tap on and your appliance will start up again after a few

minutes. Were you to be absent when these beeps are sounded, the

appliance will be blocked automatically and indicator lights 2 and 3

(wash and rinses) will flash rapidly. Turn the appliance off at the ON-

OFF button, turn on the water tap and wait approximately 20

seconds before turning the appliance back on; the selected wash

cycle will start up again.

Clogged filter alarm

If the appliance is blocked and indicator lights 1 (pre-wash) and 3

(rinses) flash rapidly, this means the filter is clogged by large particles

of food residue. Turn the appliance off, clean the filter thoroughly

and reposition it in its seat as illustrated on this page. Then turn it

back on. The selected wash cycle will start up again.

If, despite all these checks, the dishwasher still does not function

and/or the problem persists, contact the nearest authorised

service centre and provide them with the following information:

- the nature of the problem;

- the model type number (Mod. ...) and the serial number (S/

N ....), which are indicated on the plate located on the side of

the inner part of the door.

Never call on unauthorised technicians and refuse to allow

parts to be installed that are not original spare parts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Indesit dv 640 a ix Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info