101
SAVE THESE INSTRUCTIONS
Page 26
(101) MODEL 8110 KRYSTAL CLEAR™ DELUXE SALTWATER SYSTEM (SALT IN POOL) ENGLISH 7.5” X 10.3” PANTONE 295U 08/07/2008
English
TTRROOUUBBLLEESSHHOOOOTTIINNGG GGUUIIDDEE
TROUBLESHOOTING GUIDE (continued)
1. Circulation line is blocked.
2. Incorrect inlet and outlet hose
direction.
3. Flow sensor conduit incorrectly
installed.
4. Scale on the flow sensor.
5. Flow sensor cord is loose.
6. Flow sensor failure.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
1. High salt level.
• Ensure the plunger valves are opened
(if any).
• Ensure your filter cartridge, cell are
clear from debris and dirt. See
“Maintenance”.
• Release all trapped air in the circulation
line. See Filter Pump Manual.
• Check for the direction of water inlet
and water outlet hose. Reverse the
hoses if necessary. See “Set Up
Instructions”.
•
Check for the arrow on the follow sensor
conduit toward the same direction with
the one on the cell. Reverse the follow
sensor conduit if necessary.
• Ensure the flow sensor (especially the
hinge) is clean. See “Maintenance”.
• Check for flow sensor loose or not
connected properly. Plug the flow
sensor firmly into the flow sensor
receptacle.
• Contact Intex Service Center for
replacement.
• Remove the electrolytic cell for
inspection and clean it if necessary.
See “Maintenance”.
• Add salt. See “Salt & Pool Water
Volumes”.
• Check to see if cell cord is loose or not
connected properly. Ensure the cell
cord is plugged firmly into the cell
housing receptacle.
• Contact Intex Service Center. Replace
the cell if needed.
• Partially drain the pool and refill with
fresh water. See “Salt & Pool Water
Volumes”.
• Contact Intex Service Center.
LED PANEL
CODE
PROBLEM
REMED
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
