Bedienungsanleitung Intex PureSpa - 28492 PS-BH-20 (Seite 16 von 34) (Englisch)

686578

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

344

NLA

S AVE THESE INSTRUCTIONS

(344NL) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 08/09/2019

English

Page 16

OPERATION

On/Off Button: Once the unit is plugged in, press this button to active the control panel

buttons. Press this button again to turn off all currently activated functions.

Lock/Unlock Button: Press and hold this button 3 seconds to lock/unlock the control buttons.

If you forget to lock the keypad controls, the system will automatically lock it after 1 minute of

inactivity. The icon on the display is green when locked.

Control Panel Battery Indicator: The battery indicator will turn green when it is fully charged;

turn red when it requires charging and ﬂ ashing red when it is in charging mode.

Water Filter Button: This button turns the ﬁ lter pump on and off. The water ﬁ lter icon on the

display is green when activated and ﬂ ashing 002H which is the minimum preset operating

hours. Press again to increase the preset time from 002H, 004H to 006H. Pressing the button

after the maximum number of hours (006H) will turn off the ﬁ lter pump and the LED display

shows the spa water temperature. If you have selected too many hours keep pressing to repeat

the cycle. Once the operating time is set, the LED display will stop ﬂ ashing after 10 seconds

and the ﬁ lter pump starts working. The cycle repeats itself at the same time each day for the

number hours selected.

If the heating system is activated it will override the ﬁ lter pump preset time function.

To view the preset time while the ﬁ lter pump is operating, press button, the display will

brieﬂ y ﬂ ash the preset hours for 10 seconds and then display back the remaining operating

hours. To adjust the preset time, press button twice until the display is ﬂ ashing and repeat

previous steps.

NOTE: The built-in hard water treatment function works automatically in conjunction with the

ﬁ ltration system.

Water Jet Button: Use this button to activate the jet massage system. After 30 minutes of

continues use, the jet massage system will automatically turn off. The water jet icon on the

displays is green when activated. The angle of the water jet nozzles inside the spa tub wall can

be adjusted manually.

WARNING: Do not run jet system when the cover is attached, air pressure may

accumulate inside the spa and cause irreparable damage and bodily harm.

Bubble Button: Use this button to activate the massage system, which has a 30-minute

auto-shutoff feature. The bubble icon on the displays is green when activated.

CAUTION: Do not run Bubble system when the cover is attached, air can

accumulate inside the spa and cause irreparable damage and bodily harm.

SPA CONTROL PANEL

A: On/Off Button

B: Lock/Unlock Button

C Control Panel Battery Indicator

D: Water Filter Button

E: Water Jet Button

F: Bubble Button

DCB

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intex PureSpa - 28492 PS-BH-20 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Intex PureSpa - 28492 PS-BH-20

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info