790020
51
Zoom out
Zoom in
Vorherige Seite
1/116
Nächste Seite
English 51
Problem/
error
Indication on the display unit
and problem description What to do?
E9
Water detected at the bottom
ofthewashing machine
(TotalAquaStop system) Turn off the appliance and turn it back on. If the error reoccurs,
callaservicetechnician.
E10
Water level sensor error. Unplug the power cord from the outlet; then, plug the power cord back
into the outlet and switch on the washing machine. If the error reoccurs,
callaservice technician.
E11
Water overflow
If there is water in the drum that exceeds a certain level, and an error is
reported on the display unit, the washing program will be interrupted
and water will be pumped out of the washing machine. Restart the
programme. Ifthe error reoccurs, call a service technician. If there is
water in the drum that exceeds a certain level, and an error is reported
on the display unit, while the washing machine continues to add water,
close the water tap and call a service technician.
E12
Motor control error
Restart the programme. If the error reoccurs, call a service technician.
E22
Error while locking the door. Door is closed, but it cannot be locked. Switch off the washing machine.
Switchit back on and restart the washing programme. If the error
reoccurs, calla service technician.
E23
Error while unlocking the door. Door is closed, but it cannot be unlocked. Turn off the washing machine,
thenturn it back on. If the error reoccurs, call a service technician.
Toopenthedoor, see chapter »INTERRUPTIONS AND CHANGING
THEPROGRAMME/Opening the door manually«.
E36
Electronics communication
failure inthe washing machine Unplug the power cord from the outlet; then, plug the power cord back
intothe outlet and switch on the washing machine. If the error reoccurs,
calla service technician.
E37
Electronics communication
failure inthe washing machine Unplug the power cord from the outlet; then, plug the power cord back
into the outlet and switch on the washing machine. If the error reoccurs,
callaservice technician.
Water drain system alert.
Symbol will appear.
Alert about reduced water flow in the pumping stage. Check the following:
• is the pump filter clean,
• is the discharge hose clogged,
• is the drain clogged,
• if the discharge hose placed is placed below the maximum and above
the minimum height (see chapter »INSTALLATION AND CONNECTION/
Connecting and securing the water discharge hose«).
Unevenly distributed laundry
When the washing programme
is complete, the symbol will
remain lit on the display unit.
Manually distribute the laundry and run the spinning programme.
See additional description under TROUBLESHOOTING TABLE.
cln
System warning to run the Steril
tub (Self-cleaning programme)
After the washing programme
is complete, the signs »cln«
and »End« will alternate on the
display unit.
We recommend running the Steril tub [trommelreiniging]
(Self-cleaning programme).
51

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Inventum VWM9001 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info