Bedienungsanleitung Jablotron CA-1802 - Athos GSM RESET 2 (Seite 6 von 6) (Englisch)

555041

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

GSM car alarm CA-1802 „Athos“ 6/6 MHF57302

outage, the BB-02 starts to generate a voltage either for the outage

duration or until it is completely discharged. While testing it or being

handled, it is possible to protect the backup battery from being

completely discharged by briefly shorting the BB-02’s terminals (the BB-

02 has to be disconnected from the power supply). This causes

disconnection of the electronics inside the back-up battery. In the case of

switch-over to BB-02 operation (after a voltage drop under 8.5V or after

complete disconnection of the battery), an SMS will be sent with

information about backup battery operation. After the backup battery

voltage drops under 4V, an SMS will be sent about the backup battery

being discharged. An SMS will also be sent after the recovery of the

main power supply voltage (at least 10 minutes).

15. Emergency RESET

In the case of an emergency, when no installation MASTER code is

available, it is possible to perform an emergency RESET of the car alarm

even without the code. Such a reset causes the car alarm to be set to

factory defaults, including access codes (stated in the manual). Caution:

all pre-programmed numbers, LOCATOR parameters, DIP and SET

parameters will be deleted. You perform an emergency reset as follows:

Turn the power supply (including back-up battery, if any) off. Pull the SIM

card out of the car alarm and insert it into a phone, enter “RES

ET” as a name into the SIM card’s phone directory, and enter

“0” for the corresponding phone number. Insert the SIM card back into

the car alarm and turn the power supply on. The reset is indicated by 4

beeps.

Please contact us by phoning +420 483 559 987. You can also e-mail

us your suggestions to improve our services and products to

auto@jablotron.cz

16. Specification

Power supply 12-24V DC (8-32V)

Stand-by consumption max. 20 mA

Max. consumption (during GSM communication) 1 A

GSM band E-GSM / GPRS 900/1800MHz

Transmitted power 2 W for GSM900, 1 W for GSM1800

Frequency RX 868.5MHz

Operational temperature -20°C to +70°C

Output SIR +12V (24V), max. load 1.3A

Immobilization 8A permanently, 12A intermittently

Central locking outputs max. 200mA, to GND

pulses 0.5s, 4s or 60s (optional)

Complies with ECE Regulation No. 97.01

Can be operated according to ERC/DEC98(20,21), ERC REC 70-03

Safety EN 60950-1

EMC EN 55022, EN 50130-4

Radio interference ETSI EN 301 419-1, EN 301 511, ETSI EN 300 220

JABLOTRON ALARMS hereby declares that the CA-1802 is in

compliance with the essential requirements and other relevant

provisions of Directive 1999/5/EC and 1995/56/EC The original of

the conformity assessment can be found at www.jablotron.com

Technical Support section

Note: Although this product does not contain any harmful materials we

suggest you return the product to the dealer or directly to the producer

after use.

97 RAI-01 4532

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jablotron CA-1802 - Athos GSM RESET 2 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Jablotron CA-1802 - Athos GSM RESET 2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info