Bedienungsanleitung Jensen HD5112 (Seite 8 von 32) (Englisch)

509253

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

HD5112

Installation

This unit is designed for installation in cars, trucks and vans with an existing

radio opening. In many cases, a special installation kit will be required to

mount the radio into the dashboard. These kits are available at electronics

supply stores and car stereo specialty shops. Always check the kit

application before purchasing to make sure the kit works with your vehicle.

If you have trouble locating a kit or need installation assistance, contact

Technical Support at 1-800-323-4815 from 9:00am to 6:00pm EST Monday

through Friday.

Universal Installation Using Mounting Sleeve

1. Remove the detachable front panel, if it is attached to the chassis, by

pushing the “Release” button.

2. Slide the mounting sleeve off of the chassis if it has not already been

removed. If it is locked into position, use the removal keys (supplied) to

disengage it. The removal keys are depicted on page 6.

3. Check the dashboard opening size by sliding the mounting sleeve into

it. If the opening is not large enough, carefully cut or file as necessary

until the sleeve easily slides into the opening. Do not force the sleeve

into the opening or cause it to bend or bow. Check that there will be

sufficient space behind the dashboard for the radio chassis.

4. Locate the series of bend tabs along the top, bottom and sides of the

mounting sleeve. With the sleeve fully inserted into the dashboard

opening, bend as many of the tabs outward as necessary to firmly

secure the sleeve to the dashboard.

5. Place the radio in front of the dashboard opening so the wiring can be

brought through the mounting sleeve.

6. Follow the wiring diagram carefully and make certain all connections

are secure and insulated with crimp connectors or electrical tape to

ensure proper operation.

NOTE: The amplifier in this radio is only designed for use with four

speakers. Never combine (bridge) outputs for use with two speakers.

Never ground negative speaker leads to chassis ground. Failure to

wire exactly as shown may cause electrical damage to the radio.

7. After completing the wiring connections, attach the front panel and turn

the unit on to confirm operation (vehicle ignition switch must be on). If

the unit does not operate, recheck all wiring until the problem is

corrected. Once proper operation is achieved, turn the ignition switch

off and proceed with final mounting of the chassis.

8. Carefully slide the radio into the mounting sleeve making sure it is right-

side-up until it is fully seated and the spring clips lock it into place.

Mounting Bolt

Spring Washer

Plain Washer

Tapping Screw

Hex Nut

SCN

RPT

SHF

BAND

AUX

-I

MONO

MUTE

HD5112

CAT

SELECT

SRC

FILE

OLDER

A~Z

PRESS

0~ 9

iPod

ENTER

TUNE

DISP

SAT

READY

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jensen HD5112 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info