Bedienungsanleitung Jolly Motor JE50 RA9 (Seite 2 von 4) (Englisch)

626531

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

enjoy motors ®

JE 50 RA 916 radio motor is a product from Jolly Motor España, s.l. www.enjoy-motors.com 2

JE50RA-916-STEEL_eng_ver. REM 2 & REM 2T

INSTRUCTIONS TO: USE; SAFETY; INSTALLATION; PROGRAMMATION

ELECTRONIC TUBULAR MOTOR build in receiver ers916 “JE50 RA9”

JE50 RA9

2 FIRST EMITTER LEARNING (main transmitter) through a power switch OFF/ON

switch

enjoy

Connect the motor as the wires

connect way above.

Switch power ON

Within 30 seconds,

press ONE time P3 button (back

side)

Then the motor will make a single

tilt movement, indicating that it is

ready to learning the emitter

Within 5 seconds,

press ONE time UP button

Then the motor will make two tilt

movementasConrmationthat

rstemitterhasbeenlearned

NOTE:tolearntherstemitter,youmustconnectonlyonemotoronthepoweroratleastbesurethattheswitchOFF/ONisbeingdoneonthemotorwhichyouwanttolearnthe

emitter. If more than one motor are connected to the same power line and the switch OFF / ON is done on them, all of these motors will learn the emitter over is pressed the P3

button.

4 LIMIT SWITCH ADJUSTMENT - IMPORTANT

Whenweareprogrammingthelimitswitchpoints(lowerandupper),wecanndthatthedirectionofthearrowsontheremotecontroldoesnotcorrespondwiththeactualdirection

in which the roller shutter is moving. It means, is possible press UP button and the roller shutter is moving DOWNWARDS and press DOWN button and the roller shutter can moves

UPWARDS. Don’t worry for it, after set up both limit switches, motor will change by itself to the right direction.

Otherwise, you can press Up botton and motor can move UPWARDS , so it means that motor movement are in correspondence with emitter buttons.

In any case, please follow the instructions above.

NOTE: always is necessary start on the lower limit switch, it is roller shutter in its closed possition

4-1 LIMIT SWITCH ADJUSTMENT - DOWN LIMIT SWITCH (roller shutter closed)

enjoy

Move the roller shutter downwards and

STOP the motor when it reaches the

LOWER wished limit point.

Press ONE time P3 button (located on the

back of the emitter)

Then the motor will make a single tilt

movementasConrmationthatLOWER

limit switch has been set up

4-2 LIMIT SWITCH ADJUSTMENT - UP LIMIT SWITCH (roller shutter opened)

enjoy

Move the roller shutter upwards and STOP

the motor when it reaches the UPPER

wished limit point.

Press ONE time P3 button (located on the

back of the emitter)

Then the motor will make two tilt

movementasConrmationthatUPPER

limit switch has been set up

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jolly Motor JE50 RA9 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info