Bedienungsanleitung Jotul F 374 (Seite 17 von 104) (Englisch, Holländisch, Französisch, Italienisch, Spanisch)

467801

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

4.5 Control of functions

When the product is set up, always check the control functions.

These shall move easily and function satisfactorily.

Jøtul F 370 is equipped with the following controls:

Fig. 29

Air vent fig. 29 A

Pushed in: Closed

Pulled out: Open

Ignition vent, fig. 29 B

Pushed in: Closed

Pulled out: Open

Riddling grate (same handle as for the ignition vent) (Fig. 29 B)

Right handle is pushed in and out.

Handle for door fig. 29 C:

Is opened by pulling handle out.

4.6 Use

• Open the air vent and the ignition vent by pulling it out all

the way (fig. 29 A & B). If necessary, keep the door slightly

open. (Use a glove, for example, as the handle can become hot.)

• Place two medium sized logs in/out on each side of the base.

N.B. In order to avoid sooting on the glass, it is important that

the log is not placed adjacent to the glass on the product.

• Crumple some newspaper (or birch bark) between these and

add some kindling wood in a criss-cross pattern on top and

light the newspaper. (Fig. 30)

• Gradually increase the size of the fire, but the wood should

not be stacked higher than the horizontal holes on the back

burn plate. See fig. 29 H.

• Finally, place a medium-sized log on the top of the pile.

• Place 2 or 3 briquettes or kindling sticks under the top layer

of kindling and light the fire.

• NB: The maximum height of the pile of the wood should

be just below the horizontal holes. The holes must not be

covered.

• Close the ignition vent (fig. 29 B) when the firewood has

ignited and the fire is burning well.

• Check that the afterburning (secondary combustion) starts. This

is best indicated by yellow, flickering flames under the baffle.

• Then regulate the rate of combustion to the desired level of

heating by adjusting the air vent (fig. 29 A).

Fig. 30

Adding firewood

Stoke the stove frequently but only add small amounts of fuel at

a time. If the stove is filled too full, the heat created may cause

extreme stress in the chimney. Add fuel to the fire in moderation.

Avoid smouldering fires as this produces the most pollution.

The fire is best when it is burning well and the smoke from the

chimney is almost invisible.

4.7 Danger of overheating

The fireplace must never be used in a manner that

causes overheating

Overheating occurs when there is too much fuel and/or too much

air so that too much heat develops. A sure sign of overheating is

when parts of the fireplace glow red. If this happens, reduce the

air vent opening immediately.

Seek professional advice if you suspect that the chimney is not

drawing properly (too much/too little draught). For further

information, see «4.0 Installation» (Chimney and flue pipe).

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jotul F 374 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info