Bedienungsanleitung JVC GR-D43 (Seite 9 von 40) (Englisch)

662641

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

GETTING STARTED

EN 9

MasterPage: Start_Right

1 Set the Power Switch to “M”

or “PLAY” while pressing down

the Lock Button located on the

switch.

2 Open the LCD monitor fully.

(墌 pg. 10)

3 Press the MMENU/VOL.

Wheel in. The Menu Screen

appears.

4 Rotate the MMENU/VOL.

Wheel to select “n”, and

press it. The CAMERA

DISPLAY Menu appears.

5 Rotate the MMENU/VOL.

Wheel to select “BRIGHT”, and press it. The Menu

Screen closes and the brightness control indicator

appears.

6 Rotate the MMENU/VOL. Wheel until the appropriate

brightness is reached.

7 Press the MMENU/VOL. Wheel in.

● It is also possible to adjust the brightness of the viewfinder

by pulling out the viewfinder, setting “PRIORITY” in the

SYSTEM Menu to “FINDER” (墌 pg. 14, 16) and adjusting

as described above.

To attach the camcorder to a

tripod, align the direction stud

and screw to the mounting

socket and stud hole on the

camcorder. Then tighten the

screw clockwise.

● Some tripods are not

equipped with studs.

CAUTION:

When attaching the camcorder

to a tripod, extend its legs to

stabilise the camcorder. It is not advised to use small sized

tripods. This may cause damage to the unit by falling over.

The camcorder needs to be powered up to load or eject a

cassette.

1 Slide and hold OPEN/EJECT in the direction of the

arrow, then pull the cassette holder cover open until it

locks. The cassette holder opens automatically.

● Do not touch internal components.

2 Insert or remove a tape and press “PUSH HERE” to

close the cassette holder.

● Be sure to press only the section labelled “PUSH HERE” to

close the cassette holder; touching other parts may cause

your finger to get caught in the cassette holder, resulting in

injury or product damage.

● Once the cassette holder is closed, it recedes

automatically. Wait until it recedes completely before

closing the cassette holder cover.

● When the battery pack’s charge is low, you may not be able

to close the cassette holder cover. Do not apply force.

Replace the battery pack with a fully charged one or use

AC power before continuing.

3 Close the cassette holder cover firmly until it locks into

place.

Approximate recording time

To switch the recording mode, refer to pages 14 and 15.

To protect valuable recordings

Slide the erase protection tab on the back of the tape in

the direction of “SAVE”. This prevents the tape from

being recorded over. To record on this tape, slide the tab

back to “REC” before loading it.

For other notes, 墌 pg. 27.

Brightness Adjustment Of The Display

Tripod Mounting

BRIGHT

MMENU/VOL.

Loading/Unloading A Cassette

Tape

Recording mode

SP LP

30 min. 30 min. 45 min.

60 min. 60 min. 90 min.

80 min. 80 min. 120 min.

Make sure the

window side is facing

out.

Cassette holder

cover

Cassette holder

PUSH HERE

OPEN/EJECT

Erase protection tab

GR-D33EK.book Page 9 Thursday, October 30, 2003 9:41 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-D43 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC GR-D43

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info