Bedienungsanleitung JVC KW-V240BT (Seite 43 von 56) (Englisch)

682977

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Installation and ConnectionInstallation and Connection

• Do not use your own screws. Use only the screws

provided. If you use the wrong screws, you could

damage the unit.

• After the unit is installed, check whether the brake

lamps, blinkers, wipers, etc. on the car are working

properly.

• Do not press hard on the panel surface when

installing the unit to the car. Otherwise scratches,

damage, or failure may result.

• If the power is not turned on (“Miswiring DC Offset

Error”, “Warning DC Offset Error” is displayed),

the speaker wire may have a short circuit or have

touched the chassis of the car and the protection

function may have been activated. In this case, the

speaker wire should be checked.

• Keep all cables away from heat dissipating metal

parts.

• If your car’s ignition does not have an ACC position,

connect the ignition wires to a power source that

can be turned on and off with the ignition key. If you

connect the ignition wire to a power source with a

constant voltage supply, such as with battery wires,

the battery may be drained.

• If the fuse blows, first make sure the wires are not

touching to cause a short circuit, then replace the old

fuse with one with the same rating.

• Insulate unconnected wires with vinyl tape or other

similar material. To prevent a short circuit, do not

remove the caps and do not let the cable out at the

ends of the unconnected wires or the terminals.

• Secure the wires with cable clamps and wrap vinyl

tape around the wires that comes into contact with

metal parts to protect the wires and to prevent short

circuit.

• Connect the speaker wires correctly to the terminals

to which they correspond. The unit may be damaged

or fail to work if you share the · wires or ground

them to any metal part in the car.

• When only two speakers are being connected to the

system, connect both connectors either to the front

output terminals or to the rear output terminals (do

not mix front and rear). For example, if you connect

the ª connector of the left speaker to a front output

terminal, do not connect the · connector to a rear

output terminal.

Parts list for installation

Note: This parts list does not include all the package

contents.

¥ Wiring harness (× 1)

ø Extension wire, 2 m (× 1)

π Microphone, 3 m (× 1)

[ Mounting sleeve (× 1)

“ Trim plate (× 1)

] Extraction keys (× 2)

Installation procedure

1 Remove the key from the ignition and

disconnect the

· battery.

2 Make the proper input and output wire

connections for each unit.

3 Connect the speaker wires of the wiring

harness.

4 Take Connector B on the wiring harness

and connect it to the speaker connector in

your vehicle.

5 Take Connector A on the wiring harness

and connect it to the external power

connector in your vehicle.

6 Connect the wiring harness to the unit.

7 Install the unit in your car.

Make sure that the unit is installed securely in place.

If the unit is unstable, it may malfunction (e.g., the

sound may skip).

8 Reconnect the · battery.

9 Press the reset button on the monitor

panel. (Page3)

10 Configure <Initial Settings>. (Page4)

39ENGLISH

00_KW-V2018ST_E_EN.indb 3900_KW-V2018ST_E_EN.indb 39 13/6/2017 10:56:26 AM13/6/2017 10:56:26 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC KW-V240BT Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC KW-V240BT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info