Bedienungsanleitung Karcher BD 80-100 W (Seite 15 von 252) (Alle Sprachen)

804751

Zoom out

Zoom in

Vorherige Seite

1/252

Nächste Seite

English 15

BD 70/75 80 Ah:

1Battery

2Battery pole

3Circular connector

4Spacer 150x150x65

5Additional weight, 6 plates

6Additional weight, 14 plates

BD 70/75 160 Ah:

1Battery

2Battery pole

3Circular connector

4Spacer 150x150x65

5Spacer 155x300x60

5. Insert the spacers and additional

weights as indicated.

ATTENTION

Risk of damage

If the polarity (plus and minus terminal) is

reversed, the control electronics will be

damaged.

Connect the red cable to the plus terminal

and the black cable to the minus terminal.

Observe the illustrations shown above

when connecting the cables.

6. Clamp the connecting cables onto the

(+) and (-) battery terminals.

7. For the devices with two batteries, at-

tach the connecting cable between the

two batteries.

8. Plug the circular connectors into the bat-

teries.

9. Connect the device-side battery connec-

tor to the battery-side battery connector.

10.Pivot the waste water tank downwards.

Note

Charge the batteries before starting up the

device (see section "Charging the batter-

ies").

Removing the batteries

몇CAUTION

Removing and installing the batteries

Unstable machine position

Ensure that the machine is positioned sta-

bly when removing and installing the batter-

ies.

1. Turn the key-operated switch to "0" and

remove the key.

2. Disconnect the battery plug.

3. Drain the waste water.

4. Pivot the waste water tank upwards.

5. Unplug all circular connections.

6. Disconnect the device-end cable from

the negative terminal of the battery.

7. Disconnect the remaining cables from

the batteries.

8. If necessary, remove the spacers.

9. Remove the batteries.

10.Dispose of the used batteries in accord-

ance with statutory provisions.

Initial startup

Charging the battery

DANGER

Inappropriate use of the charger

Electric shock

Adhere to the mains voltage and fuse val-

ues specified on the device type plate.

Only use the charger in dry rooms with suf-

ficient ventilation.

ATTENTION

Using an unsuitable charger

Risk of damage

Do not connect the charger to the device-

side battery connector.

Use only a charger suitable for the type of

battery installed.

Read the operating instructions of the

charger manufacturer and observe the

safety instructions in particular.

The device cannot be used during the

charging process.

Note

The device has deep discharge protection,

i.e. the brush motor and turbine are

switched off automatically when the permit-

ted minimum capacity level is reached.

1. Drive the device directly to the charger

and do not drive on slopes.

2. Pull out the device-side battery connec-

tor.

1Battery plug, device side

2Battery plug, battery side

ATTENTION

Risk of damage

Do not connect the charger to the device-

side battery connector.

Note

Please read the operating instructions of

the charger manufacturer, especially the

chapters on safety instructions!

3. Connect the battery-side battery con-

nector to the charger.

4. Plug the mains plug of the charger into

the socket.

5. Carry out the charging process in ac-

cordance with the operating instructions

for the charger.

The charging time depends on the bat-

tery condition and the charger. When the

battery is empty, the charging time is ap-

proximately:

6. After the charging process is complete:

a Unplug the mains plug of the charger.

b Disconnect the battery connector from

the charger.

c Connect the device-side battery con-

nector to the battery-side battery con-

nector.

Operation

ATTENTION

Risks during operation

Danger of injury

Release the safety switch in the case of

danger.

Filling with operating materials

Filling fresh water

1. Open the fresh water tank cap.

2. Fill fresh water (max. 50 °C) to the lower

edge of the filling nozzle.

Note: The fresh water hose can be

clamped with the hose holder during fill-

ing.

3. Close the fresh water tank lock.

Notes on detergents

몇WARNING

Risk of damage to the device!

If unsuitable detergents are used, the de-

vice may get damaged.

Use only recommended detergents. The

operator carries all increased risks relating

to operational safety and increased risk of

accidents if using other detergents.

Use only detergents free of solvents, salt

and hydrofluoric acid.

Adhere to the safety instructions stated on

the detergent packaging.

Note

Do not use heavily foaming detergent.

Recommended detergents

Charger Battery ca-

pacity

Charging

time approx.

6.654-483.0 80 Ah 7 hours

6.654-484.0 80 Ah 2 hours

160 Ah 4 hours

Application Detergent

Floor maintenance cleaner

extra low foaming with EU

Ecolabel

APPROX. 50

Highly wetting universal

cleaner

RM 756

Intensive alcohol cleaner for

floors and surfaces. Well-

suited for hard rock such as

granite

RM 755

Fine stone cleaner, sur-

factant-free

RM 753

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher BD 80-100 W Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info