-10
Adjust sealing strip.
Set the distance of the sealing strip to
the floor so that the bottom edge trails
behind at a distance of between 35 and
40 mm.
Tighten nuts.
Rear sealing strip
Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 5 and 10 mm.
If worn, replace.
Remove roller brush.
Unscrew retaining nuts for rear sealing
strip.
Screw on new sealing strip.
Side sealing strips
Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
Screw on new sealing strip without fully
tightening the nuts.
To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
Adjust sealing strip.
Tighten nuts.
Screw on side panels.
Push in the waste containers on both
the sides and lock them.
몇WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
CAUTION
Risk of damage!
Do not rinse out the dust filter.
Turn main key to "0" and remove it.
Press emergency-stop button.
Open the hood, insert retaining rod.
Pull out the filter holder to the maximum
possible extent and lock.
Remove the lamella filter.
Insert new filter.
Make sure driver engages with holes on
drive side.
Lock the handle of the filter cleaner
back into place.
Note: Make sure when installing the new
filter that the fins are not damaged.
Lift filter case seal out of groove in the
cover.
Insert new seal.
Turn main key to "0" and remove it.
Press emergency-stop button.
Open the hood, insert retaining rod.
Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.
Check tension, wear and damages on
the V-belt of the sweep roller drive.
Chek the cup seal at the suction blower
regularly to see that it sits properly.
Loosen screws on both sides of the
panel.
Replace defective fuses.
Replace front panel.
Note: Only use fuses with identical safety
ratings.
Replacing dust filter
Replacing filter case seal
Checking drive belt
Check cup seal
Replacing fuses
