Bedienungsanleitung Karcher SC 3 Deluxe EasyFix (Seite 13 von 188) (Alle Sprachen)

803423

Zoom out

Zoom in

Vorherige Seite

1/188

Nächste Seite

English 13

Switching on the device

ATTENTION

Device damage due to incorrectly set water hard-

ness

The decalcification cartridge only works properly if the

device is adjusted to the local water hardness. The de-

vice may calcify if the water hardness is set incorrectly.

Adjust the device to the local water hardness before first

operation, see chapter Setting the water hardness.

Note

When steaming for the first time after removing and re-

inserting the decalcification cartridge, the steam jet may

be weak or irregular, and individual drops of water may

be expelled. The device requires a short running-in pe-

riod in which the decalcification cartridge fills with water.

The steam volume that is expelled increases constantly

until the maximum steam volume has been reached af-

ter approx. 30 seconds.

1. Place the device on a firm surface.

2. Connect the mains plug into a socket.

3. Press the On/Off switch.

Illustration I

4. The LED strip is in fading red.

5. The LED strip lights up in a constant green after ap-

prox.30 seconds.The device is ready for use.

Illustration J

Regulating the steam volume

The expelled steam volume is regulated by pressing the

steam volume button. Two different steam volume but-

tons are available:

Illustration K

Note

The maximum steam volume is always selected when

the device is switched on.

1. Press the steam lever after setting the steam vol-

ume.

2. Before starting cleaning, point the steam gun at a

cloth until steam is expelled evenly.

Topping up the water

If there is a water shortage, the LED strip rapidly flashes

red.

For constant steam output, the water has to be topped

up through the cover of the decalcification cartridge.

When topping up the water, the decalcification cartridge

remains secured in the device.

Note

The device is equipped with dry-run protection for the

pump. If the pump runs dry for a longer period, e.g. be-

cause the decalcification cartridge is not correctly in-

serted, the pump switches off and the red water

shortage indicator light flashes.

To be able to operate the device again, the device has

to be switched off and back on again. In the process,

you must make sure that the cartridge has been insert-

ed correctly and there is enough water in the water res-

ervoir.

1. Fill the water reservoir with a maximum of 1 l of tap

water through the cover of the decalcification car-

tridge.

The LED strip lights up in a constant green.

Interrupting operation

In order to save energy, we recommend that you switch

off the device for breaks in operation of longer than 20

minutes.

1. Press the On/Off switch.

Switching off the device

1. Press the On/Off switch.

Illustration L

The device has been switched off.

2. Press the steam lever until no more steam flows out.

Illustration M

The steam boiler is depressurised.

3. Move the child lock back.

The steam lever is locked.

4. Remove the mains plug from the socket.

ATTENTION

Device damage due to water putrefaction

If the device is not put into operation for more than 2

months, the water in the reservoir may putrefy.

Drain the water reservoir before breaks in operation.

5. Remove the decalcification cartridge from the de-

vice.

Illustration N

Storing the device

1. Hang the floor nozzle in the park bracket.

Illustration O

2. Connect the extension tubes to the large mounts for

accessories.

3. Connect a manual nozzle and spotlight nozzle to

each extension tube.

4. Wrap the cable and place it in the accessory storage

area.

5. Place the small round brush and power nozzle in the

accessory storage area.

6. Put the steam hose in the accessory storage area.

Illustration P

7. Store the device in a dry location that is protected

from frost.

Important application instructions

Cleaning the floor areas

We recommend sweeping the floor or vacuum cleaning

it before using the appliance. In this way the floor will be

cleared of dirt and loose particles before the wet clean-

ing.

Freshening up textiles

Prior to using the appliance, always check the compati-

bility of the textiles at a concealed point: Steam down

the textile, allow it to dry and then check it for any

change in colour or shape.

Cleaning coated or painted surfaces

ATTENTION

Damaged surfaces

Steam can loosen wax, furniture polish, plastic coatings

or paint and edge band from edges.

Maximum steam volume

Reduced steam volume

No steam - child lock

Note

In this position, the steam lever cannot

be operated.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 3 Deluxe EasyFix Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info