Bedienungsanleitung Karcher SC 3 Deluxe EasyFix (Seite 16 von 188) (Alle Sprachen)

803423

Zoom out

Zoom in

Vorherige Seite

1/188

Nächste Seite

16 English

Set the device to the current water hardness before us-

ing it in an area with a different water hardness (e.g. af-

ter a move).

Note

Your water board or municipal utilities authority can pro-

vide information on hardness of tap water.

The water hardness setting is stored until a new setting

(e.g. after a move) is made. The device is set to the

highest water hardness (level IV) in the factory. The de-

vice indicates the set water hardness with flash pulses.

Water hardness levels and flash pulses

Note

The anti-calcification effect of the decalcification car-

tridge is activated as soon as the device is filled with wa-

ter and put into operation. Lime in the water is absorbed

by the granulate in the decalcification cartridge. Addi-

tional descaling is not required.

Note

The granulate in the cartridge can discolour on contact

with water due to the mineral content in the water, which

is no cause for concern and has no negative effects on

the device, cleaning work or the functionality of the car-

tridge.

Note

Do not pause for longer than 15 seconds when setting

as the device will otherwise be set automatically to the

last selected water hardness or the highest water hard-

ness set during initial start-up.

1. Make sure that the device is switched off.

2. Press the ON/OFF button and hold it for 6 seconds.

Illustration K

3. The decalcification cartridge indicator light flashes

and signals the current water hardness setting with

the number of pulses.

4. Press the Reduced steam volume button repeatedly

to set the lower water hardness level.

5. Press the Maximum steam volume button repeated-

ly to set the higher water hardness level.

6. Release the Reduced/Maximum steam volume but-

ton.

The flash pulse for the set water hardness is indicat-

ed.

7. Repeat the process as necessary until the desired

water hardness level has been achieved.

Note

When the steam volume is pressed, the flash pulse for

the water hardness level is not indicated.

8. Press and hold the ON/OFF button for 4 seconds to

save the setting for the water hardness level. The

decalcification cartridge indicator light lights up.

Care of accessories

(Accessories - depending on scope of delivery)

Note

The micro fibre cloths are not suitable for dryer.

Note

When washing the cloths, observe the instructions on

the washing tag. Do not use any liquid softeners as this

will affect the ability of the cloths to pick up dirt.

1. Wash the floor cleaning cloths and covers at a max.

temperature of 60 °C in the washing machine.

Troubleshooting guide

Malfunctions often have simple causes that you can

remedy yourself using the following overview. When in

doubt, or in the case of malfunctions not mentioned

here, please contact your authorised Customer Service.

몇WARNING

Risk of electric shock and burns

Trying to eliminate faults while the appliance is connect-

ed to the mains or has not yet cooled down is always

dangerous.

Remove the mains plug.

Allow the appliance to cool down.

The LED strip flashes red

The dry-run protection for the pump is activated.

1. Switch the device off and back on again.

2. Make sure that the decalcification cartridge has

been inserted correctly and there is sufficient water

in the reservoir.

No water in the water reservoir.

1. Top up the water reservoir, see chapter Topping up

the water.

The steam lever cannot be pressed

The steam lever is locked with the child lock.

Move the child lock forward.

The steam lever is released.

No / little steam although there is water in the reser-

voir

The decalcification cartridge has not been inserted or

has been inserted incorrectly.

 Insert the decalcification cartridge or insert it cor-

rectly.

The decalcification cartridge has been removed while

topping up the water.

Leave the decalcification cartridge in the device

when topping up.

New decalcification cartridge has been inserted.

Press and hold the steam lever continuously.

The full steam output is reached after approximately

30 seconds.

Red “Replace decalcification cartridge” indicator

light lights up / flashes

The run time of the decalcification cartridge ends early.

Insert the new decalcification cartridge and reset the

maintenance indicator, see chapter Replacing the

decalcification cartridge.

The maintenance indicator was not reset after replace-

ment of the decalcification cartridge.

Press and hold the Maximum steam volume and

Reduced steam volume buttons at the same time

until the “Replace decalcification cartridge” indicator

light goes out after inserting the decalcification car-

tridge, see chapter Replacing the decalcification

cartridge.

The LED strip is in constantly red and no steam al-

though there is water in the reservoir

Run time for the decalcification cartridge has expired

Insert the new decalcification cartridge and reset the

maintenance indicator, see chapter Replacing the

decalcification cartridge.

Hardness

range

°dH mmol/l Number

of flash

pulses

Interval

between

flash

pulses

I Soft 0-7 0-1.3 1x 4 seconds

II Medium 7-14 1.3-2.5 2x

III Hard 14-21 2.5-3.8 3x

IV Very

hard

>21 >3.8 4x

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 3 Deluxe EasyFix Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info