Bedienungsanleitung Karcher SC 3 EasyFix Premium Plus (Seite 13 von 186) (Alle Sprachen)

724886

Zoom out

Zoom in

Vorherige Seite

1/186

Nächste Seite

English 13

Regulating the steam volume

The expelled steam volume is regulated using the se-

lector switch for steam volume. The selector switch has

3 positions:

1. Set the selector switch for the steam volume to re-

quired steam volume.

2. Press the steam lever.

3. Before starting cleaning, point the steam gun at a

cloth until steam is expelled evenly.

Topping up the water

If there is a water shortage, the red water shortage indi-

cator light lights up constantly.

For constant steam output, the water has to be topped

up through the cover of the decalcification cartridge.

When topping up the water, the decalcification cartridge

remains secured in the device.

Note

The device is equipped with dry-run protection for the

pump. If the pump runs dry for a longer period, e.g. be-

cause the decalcification cartridge is not correctly in-

serted, the pump switches off and the red water short-

age indicator light flashes.

To be able to operate the device again, the device has

to be switched off and back on again. In the process,

you must make sure that the cartridge has been insert-

ed correctly and there is enough water in the water res-

ervoir.

1. Fill the water reservoir with a maximum of 1 l of tap

water through the cover of the decalcification car-

tridge.

The red water shortage indicator light goes out.

Interrupting operation

In order to save energy, we recommend that you switch

off the device for breaks in operation of longer than 20

minutes.

1. Press the Off switch.

Switching off the device

1. Press the Off switch.

Illustration O

The device has been switched off.

2. Press the steam lever until no more steam flows out.

Illustration P

The steam boiler is depressurised.

3. Set the child lock (selector switch for steam volume)

to the rear.

The steam lever is locked.

4. Pull the mains plug from the socket.

ATTENTION

Device damage due to water putrefaction

If the device is not put into operation for more than 2

months, the water in the reservoir may putrefy.

Drain the water reservoir before breaks in operation.

5. Drain the water reservoir.

Illustration S

Storing the device

1. Connect the extension tubes to the large mounts for

accessories.

2. Connect a manual nozzle and spotlight nozzle to

each extension tub

3. Fasten the large round brush to the spotlight nozzle.

4. Connect the small round brush and nozzles to the

medium-sized mount for accessories.

5. Hang the floor nozzle in the park bracket.

Illustration Q

6. Wind the steam hose around the extension tube and

connect the steam gun to the floor nozzle.

Illustration R

7. Wind the mains cable around the extension tube.

8. Store the device in a dry location that is protect

om frost.

Important application instructions

Cleaning the floor areas

We recommend sweeping the floor or vacuum cleaning

it before using the appliance. In this way the floor will be

cleared of dirt and loose particles before the wet clean-

ing.

Freshening up textiles

Prior to using the appliance, always check the compati-

bility of the textiles at a concealed point: Steam down

the textile, allow it to dry and then check it for any

change in colour or shape.

Cleaning coated or painted surfaces

ATTENTION

Damaged surfaces

Steam can loosen wax, furniture polish, plastic coatings

or paint and edge band from edges.

Do not direct the steam at glued laminated edges as the

edge band may loosen.

Do not use the appliance for cleaning unsealed wood or

parquet floors.

Do not use the appliance for cleaning painted or plastic

coated surfaces such as kitchen or living room furniture,

doors or parquet.

1. To clean these surfaces, steam a cloth briefly and

use it to wipe over the surfaces.

Glass cleaner

ATTENTION

Glass breakages and damaged surfaces

Steam can damage sealed points of the window frame

and, at low outside temperatures, lead to tension on the

surface of window panes and hence to glass breakages.

Do not direct the steam at sealed points on the window

frame.

At low outside temperatures, heat up the window panes

by gently steaming the full surface of the glass.

 Clean the window area with a manual nozzle and

cover. To remove the water, use a squeegee or wipe

the surfaces dry.

How to use the Accessories

Steam gun

The steam gun can be used for the following applica-

tions without accessories:

 For removing slight creases from the hanging cloth-

ing items: Steam the clothing item from a distance of

10-20 cm.

 For wiping damp dust: Steam a cloth briefly and use

it to wipe over the furniture.

Maximum steam volume

Reduced steam volume

No steam - child lock

Note

In this position, the steam lever cannot

be operated.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 3 EasyFix Premium Plus Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info