Bedienungsanleitung Karcher SC 3 EasyFix Premium Plus (Seite 15 von 186) (Alle Sprachen)

724886

Zoom out

Zoom in

Vorherige Seite

1/186

Nächste Seite

English 15

Removing the carpet glider from the floor nozzle

몇 CAUTION

Beware of burns to your feet

The carpet glider can heat up during the steaming pro-

cess.

Do not operate or remove the carpet glider bare-footed

or using open sandals.

Only operate or remove the carpet glider using suitable

footwear.

1. Press the strap on the carpet glider downwards us-

ing your toecap.

2. Lift the floor nozzle upwards.

Illustration M

Care and service

Draining the water reservoir

ATTENTION

Device damage due to water putrefaction

If the device is not put into operation for more than 2

months, the water in the reservoir may putrefy.

Drain the water reservoir before breaks in operation.

1. Press the Off switch.

The device has been switched off.

2. Pull the mains plug out of the socket.

3. Remove the accessories from the accessory holders.

4. Remove the decalcification cartridge from the de-

vice.

5. Drain the water reservoir.

Illustration S

Replacing the decalcification cartridge

ATTENTION

Device damage and shortened service life

If the replacement intervals (indicator light) for the de-

calcification cartridge are not observed, there is a risk of

device damage and the service life of the device may be

shortened.

Observe the replacement intervals (indicator light).

Note

The replacement intervals depends on the local water

hardness. Areas with hard water (e.g. III/IV) have a

higher replacement interval than areas with soft water

(e.g. I/II).

Indicator lamp at end of the run time

The "decalcification cartridge indicator light" indicates

when the decalcification cartridge has to be replaced:

 The indicator light flashes 2 hours before the run

time expires.

 The indicator light flashes more quickly 1 hour be-

fore the run time expires.

 Once the run time for the decalcification cartridge

has expired, the indicator light lights up constantly

and the device switches off automatically in order to

prevent device damage.

Inserting the decalcification cartridge

ATTENTION

Device damage

There is a risk of damage to the device if the used de-

calcification cartridge is re-used.

Work carefully in order to prevent mixing up the cartridg-

es.

Note

When steaming for the first time after removing and re-

inserting the decalcification cartridge, the steam jet may

be weak or irregular, and individual drops of water may

be expelled. The device requires a short running-in pe-

riod in which the decalcification cartridge fills with water.

The steam volume that is expelled increases constantly

until the maximum steam volume has been reached af-

ter approx. 30 seconds.

1. Press the Off switch.

The device has been switched off.

2. Remove the decalcification cartridge.

3. Insert the new decalcification cartridge.

4. Press the On switch.

The device is switched on.

5. Press and hold the RESET key for 4 seconds.

The "replace decalcification cartridge" indicator light

goes out and the run time for the decalcification car-

tridge starts again.

6. Allow the device to heat up.

7. Press and hold the steam lever for approximately 30

seconds to vent the decalcification cartridge.

Setting the water hardness

ATTENTION

Device damage due to calcification

Without a decalcification cartridge, the device may cal-

cify if the water hardness is set incorrectly.

Always work with a decalcification cartridge.

Set the device to the local water hardness.

Set the device to the current water hardness before us-

ing it in an area with a different water hardness (e.g. af-

ter a move).

Note

Your water board or municipal utilities authority can pro-

vide information on hardness of tap water.

The water hardness is set using the RESET key. The

water hardness setting is stored until a new setting (e.g.

after a move) is made. The device is set to the highest

water hardness (level IV) in the factory. The device indi-

cates the set water hardness with flash pulses.

Water hardness levels and flash pulses

Note

The anti-calcification effect of the decalcification car-

tridge is activated as soon as the device is filled with wa-

ter and put into operation. Lime in the water is absorbed

by the granulate in the decalcification cartridge. Addi-

tional descaling is not required.

Note

The granulate in the cartridge may change colour after

it comes into contact with water. This depends on the

mineral content in the water. This discolouration is

harmless and does not have a negative effect on the de-

vice, cleaning work or the functionality of the decalcifi-

cation cartridge.

Note

Do not pause for longer than 15 seconds when setting

as the device will otherwise be set automatically to the

last selected water hardness or the highest water hard-

ness set during initial start-up.

1. Connect the mains plug.

2. Make sure that the device is switched off.

Hardness

range

°dH mmol/l Number

of flash

pulses

Interval

between

flash

pulses

I soft 0-7 0-1.3 1x 4 seconds

II Medium 7-14 1.3-2.5 2x

III Hard 14-21 2.5-3.8 3x

IV Very

hard

>21 >3.8 4x

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 3 EasyFix Premium Plus Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info