Bedienungsanleitung Karcher SC 3 Upright EasyFix Premium (Seite 15 von 188) (Alle Sprachen)

724890

Zoom out

Zoom in

Vorherige Seite

1/188

Nächste Seite

English 15

Carpet glider

The carpet glider is used for freshening up carpets.

ATTENTION

Beware of damaging the carpet glider and carpet

Contamination on the carpet glider, as well as heat and

moisture penetration, can result in the carpet being

damaged.

Use the carpet glider only with a microfibre floor cloth on

the floor nozzle.

Steam clean using only the correct steam stage when

using the carpet glider (see the display indicator on the

handle, carpet floor covering symbol - medium steam

stage).

Prior to the application, also check the heat resistance

and impact of steam on the carpet at an insignificant

spot using the smallest steam volume.

Observe the cleaning instructions from the carpet man-

ufacturer.

Prior to using the carpet glider, make sure that the car-

pet has been vacuumed and that stains have been re-

moved.

Prior to use and following operating pauses, remove

any possible water accumulation (condensate) in the

device by evaporating the condensate into a drain (with-

out floor cleaning cloth / with accessories).

In order to prevent too much moistening and to avoid

the risk of damage due to temperature effects, do not di-

rect the steam continuously onto one spot (maximum

5 seconds).

Do not use the carpet glider on deep-pile carpets.

Fastening the carpet glider to the floor nozzle

1. For fastening the floor cleaning cloth to the floor

nozzle, please refer to chapter Floor nozzle.

Illustration D

2. Using light pressure, allow the floor nozzle to slide

into the carpet glider and engage there.

Illustration E

3. Start cleaning the carpet.

Removing the carpet glider from the floor nozzle

몇CAUTION

Beware of burns to your feet

The carpet glider can heat up during the steaming pro-

cess.

Do not operate or remove the carpet glider bare-footed

or using open sandals.

Only operate or remove the carpet glider using suitable

footwear.

1. Press the strap on the carpet glider downwards us-

ing your toecap.

2. Lift the floor nozzle upwards.

Illustration E

Care and service

Draining the water reservoir

ATTENTION

Device damage due to water putrefaction

If the device is not put into operation for more than 2

months, the water in the reservoir may putrefy.

Drain the water reservoir before breaks in operation.

1. Press the OFF switch.

The device is switched off.

2. Pull the mains plug out of the socket.

3. Remove the reservoir cover.

4. Drain the water reservoir.

The cartridge can remain the water reservoir.

Illustration U

Replacing the decalcification cartridge

ATTENTION

Device damage and shortened service life

If the replacement intervals (indicator light) for the de-

calcification cartridge are not observed, there is a risk of

device damage and the service life of the device may be

shortened.

Observe the replacement intervals (indicator light).

Note

The replacement intervals depends on the local water

hardness. Areas with hard water (e.g. III/IV) have a

higher replacement interval than areas with soft water

(e.g. I/II).

Indicator lamp at end of the run time

The "decalcification cartridge indicator light" indicates

when the decalcification cartridge has to be replaced:

The indicator light flashes 2 hours before the run

time expires.

Illustration R

The indicator light flashes more quickly 1 hour be-

fore the run time expires.

The indicator light and the LED strip on the device

light up when the run time of the decalcification car-

tridge has expired. The floor covering symbols on

the handle do not light up. The pump switches off

automatically (no water steam) to prevent damage

to the device.

Inserting the decalcification cartridge

ATTENTION

Device damage

There is a risk of damage to the device if the used de-

calcification cartridge is re-used.

Work carefully in order to prevent mixing up the cartridg-

es.

Installation information

When steaming for the first time after removing and re-

inserting the decalcification cartridge, the steam jet may

be weak or irregular, and individual drops of water may

be expelled. The device requires a short running-in pe-

riod in which the decalcification cartridge fills with water.

The steam volume that is expelled increases constantly

until the maximum steam volume has been reached af-

ter approx. 30 seconds.

Note

Removing the water reservoir makes it easier to remove

and install the decalcification cartridge.

1. Press the OFF switch.

The device is switched off.

2. Remove the reservoir cover.

3. Remove the decalcification cartridge.

4. Insert the new decalcification cartridge and press it

firmly into place.

5. Press the On switch.

The device is switched on.

6. Press and hold the RESET button for 4 seconds.

The "replace decalcification cartridge" indicator light

goes out and the run time for the decalcification car-

tridge starts again.

Illustration Q

7. Allow the device to heat up.

8. Press and hold the steam lever for approximately 30

seconds to vent the decalcification cartridge.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 3 Upright EasyFix Premium Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info