Bedienungsanleitung Karcher SC 3 (Seite 15 von 186) (Alle Sprachen)

657212

Zoom out

Zoom in

Vorherige Seite

1/186

Nächste Seite

– 9

Illustration

 During work breaks, hook the floor nozzle into the

parking holder.

ATTENTION

If the device is not used for a longer period of time (ap-

prox. 2 months), please empty the water tank. This

avoids decomposition of the water.

 Press the OFF switch to turn off the appliance.

 Disconnect the mains plug from the socket.

 Remove the accessories from the accessory com-

partments.

 Remove the cartridge from the device.

Illustration

 Completely empty the water tank to remove exist-

ing water.

ATTENTION

The replacement intervals of the cartridge (display indi-

cator light) must be complied with; otherwise the service

life of the device is reduced.

If the cartridge is not replaced in the indicated intervals,

irreparable damage can be caused on the device.

Note

 The replacement intervals depend on the local wa-

ter hardness. Areas with harder water (e.g. III/IV)

have a shorter replacement interval than areas with

softer water (e.g. I/II).

The necessary cartridge replacement is indicated via

the indicator light "Replacement cartridge" by the follow-

ing actions:

 Two hours before the end of the operating time the

necessary replacement is indicated by flashing.

 One hour before the end of the operating time the

indicator light flashes faster.

 If the operating time of the cartridge is completely

depleted, the indicator light "Replacement car-

tridge" is continuously on and the device switches

itself off in order to prevent damage to the device.

 Press the OFF switch to turn off the appliance.

 Remove the cartridge from the device.

 Insert new cartridge into the device.

 Press the ON switch to turn on the appliance.

 Hold down the RESET button for 4 seconds.

Then the indicator light "Replacement descaler car-

tridge" goes out and the operating time of the car-

tridge starts again.

 Allow the device to warm up.

 Then hold down the steam lever for approx. 30 sec-

onds to bleed the cartridge.

Note

During the first steaming after removal and reinserting

the cartridge the blast of steam can still be a little weak.

The device requires a short break-in period, as the car-

tridge has to be filled with water first. This is why the

steam discharge is unsteady at first and single water

drops may exit. The amount of escaping steam increas-

es continuously until the maximum amount is reached

after approx. 30 seconds.

ATTENTION

When replacing the cartridge, ensure that there is no

confusion and the old cartridge is not reinserted.

Note

The floor cleaning cloth and the cloth cover have been

pre-washed and can be used immediately for working

with the steam cleaner.

 You can wash dirty floorcloths and cloth covers in

the washing machine at 60°C. Do not use a liquid

softener as this would affect the ability of the cloths

to pick up dirt. You may tumble dry the terry cloths.

The microfiber cloths are not suitable for the tum-

ble.

Often, failures have simple causes and you can do the

troubleshooting yourself using the following overview. If

you are in doubt or if the failure is not listed here please

contact the authorized customer service.

No water in the water reservoir.

 Refill water

Dry run protection of the pump is activated.

 Switch on/off the appliance again.

 Ensure that the cartridge is inserted correctly and

there is enough water in the water tank.

Descaler cartridge not inserted or inserted incorrectly.

 Insert cartridge or ensure tight / correct seating.

Descaler cartridge was removed during the filling of the

water or a new descaler cartridge was inserted.

 Leave the cartridge in the device during filling.

 Hold the steam lever down permanently, after 30

seconds the full steam output is reached.

Steam switch is secured with the lock / child-proof lock.

 Move the selector switch for the steam volume to

the front.

 Insert new cartridge and reset the maintenance dis-

play.

See Chapter "Insert new descaler cartridge".

 Hold down the RESET button for 4 seconds after

inserting the cartridge.

 Insert new cartridge into the device.

See Chapter "Insert new descaler cartridge".

Parking the floor nozzle

Care and maintenance

Emptying the water tank

Replacement descaler cartridge

Indicator light display at the end of the operating

time

Insert new descaler cartridge.

Care of the Accessories

Troubleshooting

No steam

Indicator light - water shortage is continuously red

Indicator light - water shortage flashes red

No / little steam despite enough water in the water

tank

Steam lever cannot be pressed anymore

Indicator light "Replacement descaler

cartridge" is on / flashes red

Operating time of the cartridge completed soon

RESET button was not pushed after the

replacement of the cartridge

The device switches off automatically

Operating time of the cartridge over

15EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 3 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info