Bedienungsanleitung Katadyn PowerSurvivor 80E (Seite 13 von 36) (Englisch)

522392

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Note: Organic growth is much more rapid in warm or tropical climates. If using the

watermaker in a tropical environment, we recommend a membrane preservative treatment if

the watermaker will not be run again within the next three days! Before doing repairs or

maintenance work on a PowerSurvivor, close the seawater inlet valve after turning

off the system. Otherwise, the possibility exists that hose failure, for example, could

cause the boat to sink.

At the end of a watermaker run, check the condition of water in the prefilter housing. If there is

evidence of trapped material, clean the prefilter housing and install a clean prefilter element.

Special Conditions

Product freshwater output volume will vary depending on the salinity and temperature of the

seawater being processed. Figure 6 illustrates the relationship between feed water

temperature and the quantity of product water.

Factors which are known to affect output or per-

formance include:

• High Salinity will decrease output

slightly and lead to a modest increase in

current draw. Effectively, the pump must

work harder to remove a larger

percentage of dissolved solids from the

seawater.

• Cold Water will have an effect similar to

that of high salinity.

• Silt or Sand can damage the membrane

and internal pump components if not

removed during prefiltration. If you must

regularly process such water, consider

installing a Silt Reduction Kit (see Kits

& Accessories).

• Foul Intake Seawater can seriously effect the quality of the product freshwater. The

watermaker membrane is designed to remove the impurities found in clean, open ocean

seawater. Processing of seawater with other kinds of impurities (1) may not remove

those impurities and (2) may damage or destroy the membrane. See Maintenance and

Service: Prefilter Maintenance below for more information on typical problems

associated with foul water intake.

• Low Battery Voltage will dramatically reduce the volume of seawater throughput and

product freshwater output. We recommend not operating the watermaker if battery

voltage is below 11 VDC.

Note on Red Tides: In many areas of the ocean, a phenomenon generally known as a

“red tide” can occur. This generic name is used to describe an invasion of local waters by

huge populations of micro-organisms, which turns the seawater red. Occasionally, a red tide

is accompanied by the death of local fish and other sea life, which can cause serious local

pollution of the seawater. Although the watermaker membrane can remove the

microorganisms that cause the red tide, it can not remove all of the chemical pollutants

caused by large-scale biological decomposition. Therefore, we do not recommend using the

watermaker to process seawater when a red tide is present.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Katadyn PowerSurvivor 80E Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Katadyn PowerSurvivor 80E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info