Bedienungsanleitung Katadyn Vario (Seite 6 von 10) (Englisch)

522426

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

To change the filter mode, detach pump head by turning and lifting the handle from

the filter housing. Hold the housing in one hand and turn the ceramic prefilter unit until

the white arrow points to the desired mode. Reattach pump head and close tight

(Picture D).

Note

: The ceramic prefilter can easily be cleaned by brushing with the supplied clean-

ing pad.

2) Connect Hoses

Remove the red plastic cap from the input barb; retain for storage. Connect input hose

(with prefilter) to input barb in the middle of the pump head. To use with hydration

bladder, connect bladder drink tube to the outlet of the bottom cap. To use with output

hose, remove the bottom cap and attach the output hose to the output barb. Push the

bottle clip on to the output hose. (Figure 1-1, Pictures B, C)

3) Flush System

Important

: Before first use, flush system by pumping approximately 1 liter of water

through the unit to remove harmless carbon dust. Slightly discolored water is normal

when flushing. See following section on Normal Operation on how to filter water.

Normal Operation

1) Place input hose in untreated water source. Adjust the float to keep prefilter off the bot-

tom and away from sediment.

2) Remove the bottom cap and retain. Connect a Nalgene Bottle to the bottom of the Vario

filter or attach the output hose to the output barb. Alternatively connect hose of hydra-

tion bladder as described above *. (Pictures A, B, C)

3) Make sure the hoses are not kinked. Pump the handle in a slow, steady manner.

Approximately 38 strokes per minute equals 1 liter of water in FASTER FLOW mode.

4) After filling water container with filtered water, unscrew bottle/remove outlet

hose/remove bladder drink tube and remove prefilter from water source. Continue

pumping to remove remaining water from pump body. If applicable, screw bottom cap

back on housing. To protect the inside from dirt, turn outlet hole until covered. in the

resealable bag inside the carry bag.

5) Store unit in the carry bag. To prevent the possibility of cross contamination, store the

output hose with the clip separately in the resealable bag inside the carry bag.

*Note

: Before each use, flush and discard a small amount (5 – 10 strokes) of water to

remove stale taste.

Field Performance Tips

The Katadyn Vario is designed to remove bacteria and protozoan cysts

such as Giardia and Cryptosporidium. To extend cartridge life, always

use the best water source available. Keep the intake prefilter clean and off the bot-

tom. In heavy sediment conditions, wrap a coffee filter or bandanna around the intake pre-

filter. Where possible, place untreated water in container and wait for sediment to settle out

until water appears clear - then filter from water above the sediment.

063268 Katadyn-8015062-B:Vario Filter multi-manual 25.10.2006 7:42 Pag

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Katadyn Vario Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Katadyn Vario

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info