Bedienungsanleitung Kathrein CAP 620 - MobiSet 2 Twin (Seite 10 von 68) (Englisch)

631717

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

10 of 68

5 Installation and connection

5�1 Required tools and equipment

5�2 Unpacking and preparation

5�3 Selecting the installation location

● Circular cutter, Ø 38 mm

● Flat-bladed screwdriver for M5 screws

● Power drill

● Galvanised round head screws, depending

on the roof structure (Ø: 5 mm, sheet metal

screws D 7981, depending on the roof struc-

ture) or round head screws D 7985 with wash-

ers and nuts

● Twist drill, Ø 2.5 or 5.5 mm

● Roundleand/oremerypaper

● Cleaning agent

● Open-ended or ring spanners 10 and 11 mm

acrossats

● Knife

● Cross-head screwdriver for M3 and M5 screws

● Torque wrench capacity 6 to 11 Nm

● Hexagonsocketkey(5mm)

● Two wooden beams for supporting the turnta-

ble

Essentially, the cable lengths and components that are supplied allow you a free choice of installation loca-

tion on your caravan or motor home. However, you should take note of the following points:

● Beforeinstallation,youshouldndoutwhethertheoperatingmanualforyourvehiclepermitsthetting

ofnon-vehicle-specicpartsorwhatrequirementsneedtobemetinordertodoso.

● For direct satellite reception, there should be no obstructions between the antenna and the satellite.

Therefore, make sure that the antenna is not shadowed by roof attachments such as luggage racks,

air conditioning units, solar panels, etc. The problem of shadowing applies also when selecting a park-

ing place for your vehicle. For interference-free satellite reception, the antenna needs a free view to the

south at an angle of between 0° and 55° (depending on location) to the horizontal.

● When selecting the installation location, take into account the range of movement of the turntable (see

graphics and the “Technical data” chapter). There must not be any attachments on the roof that would

obstruct this range of movement (risk of collision). To be on the safe side, keep slightly more than the

Important

The turntable must not be carried by the planar antenna,

since this can cause it to distort. Keep the system in its

cardboardboxfortransportontothevehicleroof.

Retain the original packaging, as if it is necessary to send the unit

for repair, transport damage cannot be ruled out and the manufac-

turer accepts no liability for possible damage.

The packaging of the turntable can be opened along the centre.

This makes it easier to access the fastening screws once the

system and inserts have been taken out of the packaging.

Loosenthesixfasteningscrews(10mmacrossats).Carefullylift

the turntable off the mounting plate and place it on the two prepared

wooden supports. Make sure that the cables are not crushed where

they emerge from the underside of the turntable.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kathrein CAP 620 - MobiSet 2 Twin Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kathrein CAP 620 - MobiSet 2 Twin

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info