Bedienungsanleitung Kathrein CAP 730 - MobiSet 3 Twin (Seite 8 von 64) (Englisch)

631709

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

8 from 64

Safety instructions – important notes

RoadTrafcLicensingRegulations(StVZO)

TheapplicableregulationsoftheGermanStVZOmustbeobservedinrespectofxedinstallationofthe

turntable on a vehicle which is driven on public highways.

In particular, Articles 19/2; 30 C; 32 (2) and EC directive 74/483 EEC are applicable.

Briey,theystatethatnoendorsementofthevehicledocumentationisrequiredunlesstheantennaunit

causes the height of the laden vehicle to exceed 2 m, or the antenna unit projects beyond the outer lat-

eral outline of the vehicle. The maximum permissible height of 4 m (vehicle and antenna unit) may not be

exceeded.

Warning

There is an increased risk of accidents if the normal vehicle height is increased by extend-

ing the antenna. The driver bears sole responsibility for the condition of the superstructure

andexternalttings!

Cables

Lay all cables such that nobody can tread on them or trip over them.

Topreventparasiticinductionorinterferenceemissions,whenextendingtheantennacableuse75Ωcoax-

ial cable with a screening factor of at least 75 dB.

Warning

If you tied the cables together with wire or similar materials, remove this to prevent the risk

ofre!

When connecting the power cables (receiver and turntable) to the vehicle electrical supply, make sure that

the cable polarity is not reversed.

Important

If the cable polarity is reversed there is a risk of thermal overload and damage to compo-

nentswhentheequipmentispoweredup!

Power supply, fusing

Operate the system from your vehicle's battery (12 V) or a suitable power supply unit. This power supply

unit must ensure a stable output voltage of 12 V, a continuous current of 11 A and 15 A (300 ms) surge cur-

rent.

The peak current consumption is up to a maximum of 12 A.

To ensure reliable functioning of the connection / control unit, the power supply cable must be connected

directly to the battery. If the supply voltage is too low, the receiver indicates this with the on-screen mes-

sage “On-board voltage too low” on the television screen.

A 15 A fuse is incorporated in the power supply cable. If the fuse blows, rectify the source of the fault and

replace the blown fuse with a fuse of the same rating (15 A).

Warning

 Neverremoveorbypassthefuseinthecable–cablerehazard!

Connecting the power supply cable lead marked "Ignition" activates the turntable function for automatic

lowering of the antenna. This lowering takes place as soon as the vehicle ignition circuit is turned on.

When connecting the control unit to the vehicle power supply, make sure that the “12 V”, “Earth” and “Igni-

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kathrein CAP 730 - MobiSet 3 Twin Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kathrein CAP 730 - MobiSet 3 Twin

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info