Bedienungsanleitung Kaysun KAY-CF 71 DR8 (Seite 21 von 36) (Englisch)

771401

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

CORRECT

Make sure there are no kinks

or dent in drain hose to ensure

proper drainage.

INCORRECT

Kinks in the drain hose

will create water traps.

INCORRECT

Kinks in the drain hose

will create water traps.

INCORRECT

Do not place the end of the

drain hose in water or in

containers that collect water.

This will prevent proper

drainage.

 Page 21 

Step 5: Connect drain hose

By default, the drain hose is attached to the left-hand side

of unit (when you're facing the back of the unit). However,

it can also be attached to the right-hand side. To ensure

proper drainage, attach the drain hose on the same side

that your refrigerant piping exits the unit. Attach drain

hose extension (purchased separately) to the end of drain

hose.

• Wrap the connection point rmly with Teon tape to

ensure a good seal and to prevent leaks.

• For the portion of the drain hose that will remain

indoors, wrap it with foam pipe insulation to prevent

condensation.

• Remove the air lter and pour a small amount of

water into the drain pan to make sure that water ows

the unit smoothly.

NOTE ON DRAIN HOSE PLACEMENT

Make sure to arrange the drain hose according to the

following gures.

PLUG THE UNUSED DRAIN HOLE

To prevent unwanted leaks you mst

plug the unused drain hole with the

rubber plug provided.

BEFORE PERFORMING ANY

ELECTRICAL WORK, READ THESE

REGULATIONS

1. All wiring must comply with local and national

electrical codes, regulations and must be installed by

a licensed electrician.

2. All electrical connections must be made according

to the Electrical Connection Diagram located on the

panels of the indoor and outdoor units.

3. If there is a serious safety issue with the power supply,

stop work immediately. Explain your reasoning to the

client, and refuse to install the unit until the safety

issue is properly resolved.

4. Power voltage should be within 90-110% of rated

voltage. Insufcient power supply can cause

malfunction, electrical shock, or re.

5. If connecting power to xed wiring, install a surge

protector and main power switch with a capacity of

1.5 times the maximum current of the unit.

6. If connecting power to xed wiring, a switch or

circuit breaker that disconnects all poles and has

a contact separation of at leasr 1/8in (3mm) must

be incorporateed in the xed wiring. The qualied

technician must use an approved circuit breaker or

switch.

7. Only connect the unit to an individual branch circuit

outlet. Do not connect another appliaance to that

outlet.

8. Make sure to properly ground the air conditioner.

9. Every wire must be rmly connected. Loose wiring

can cause the terminal to overheat, resulting in

product malfunction and possible re.

10. Do not let wires touch or rest against refrigerant

tubing, the compressor, or any moving parts within

the unit.

11. If the unit has an auxiliary electrich heater, it must

be installed at least 1 meter (40in) away from any

combustible materials.

12. To avoid getting an electric shock, never touch the

electrical components soon after the power supply

has been turned off. After turning off the power,

always wait 10 minutes or more before you touch the

electrical components.

WARNING

BEFORE PERFORMING ANY ELECTRICAL OR

WIRING WORK, TURN OFF THE MAIN POWER TO

THE SYSTEM.

Step 6: Connect signal cable

The signal cable enables communication between the

indoor and outdoor units. You must rst choose the right

cable size before preparing it for connection

Cable Types

• Indoor Power Cable (if applicable): H05VVF- or

H05V2V2-F.

• Outdoor Power Cable: H07RN-F

• Signal Cable: H07RH-F

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kaysun KAY-CF 71 DR8 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kaysun KAY-CF 71 DR8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info