510826
6
Zoom out
Zoom in
Vorherige Seite
1/144
Nächste Seite
6
The induction hob will change to
standby mode if it is not operated
within one minute.
In use, unless a suitable pan of at
least 12cm diameter is used a
beep will sound for approximately 
1 minute. If an appropiate pan is 
not placed onto the surface in this
time the induction hob automatically
change to standby mode.
If the appliance overheats or pans 
boil dry, the induction hob
automatically enters a protective
condition where its heating is then 
regulated. If the overheating 
continues, the appliance may
display a protection code (see 
troubleshooting guide).
During use if there are problems with 
the mains supply, induction hob
automatically enters a protective 
state and displays a protection code.
Unplug the appliance and wait for
supply to return to normal (see 
troubleshooting guide).
If the induction hob is cooking and
no button is pressed after 2 hours it
will automatically change to standby
mode.
Once the pan is moved away, the hob 
stops cooking.
safety features
care & cleaning
Switch off, unplug and allow the
appliance to cool down completely
before cleaning.
Never immerse the induction hob in
water.
Hob plate, body and control
panel:
Wipe with a soft damp cloth or non
– abrasive cleaner and dry
thoroughly. Ensure all traces of
cleaner are removed. Do not use
abrasive or scouring
detergents/powders, scouring pads
or steel wool as they will damage or
crack the hob plate or damage the
control panel.
Dust, fat and liquids from food that
has boiled over must be removed as
soon as possible. If they are allowed
to harden they become increasingly
difficult to remove. Do not use a
knife or other sharp utensil as these
may damage the hob plate or
control panel.
Air entry and air vent:
After long periods of use dirt and
dust may accumulate in the air entry
or air vent. Clean with a soft flexible
brush. Never wash using water.
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

kenwood-ih470-series

Suche zurücksetzen

  • Wie funktioniert das Gerät?
    das Display blinkt L Eingereicht am 12-7-2020 09:34

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kenwood IH470 series wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info