18
GB
control programs.
1. Switch on the device.
2. Attach the safety key to the treadmill and the clip to the clothes
of the user.
3. Select the “P6: HRC Speed Program” with the cursor buttons
and confirm with Enter
4. Confirm (Enter) or change (Cursors buttons) the age input
5. Confirm (Enter) or change (Cursors buttons) the time input
6. Confirm (Enter) or change (Cursors buttons) the maximum tar-
get pulse
7. Confirm with Enter to begin the training.
8. The training can be interrupted at any time by pressing the
STOP button. A restart of the training is possible during the first
3 minutes.
P6: Pulse Profile
Note for Heart Control Programs:
If the heart rate is not detected, due to safety reasons the speed
will be limited to 1km/h(metric), 0.6MPH(English).
SYSTEM CHANGEOVER
The menu items for Unit (metric/English), LCD and Controller Ver-
sion, Total Running Time, Total Running Performance, Buzzer
(ON/OFF) and Stand-by Time can be adjusted individually. The
LCD and Controller Version, Total Running Time and Total Running
Performance can only be read but not edited.
To be able to carry out a system changeover you must be in the pro-
gram selection.
Press the SPEED button (-) for at least 2 sec. to enter the system
changeover menu.
You can leave the adjustment mode without any changes at any
time by using the STOP button.
You can navigate through further menu points by pressing the but-
tons SPEED (-) or SPEED (+).
1) Change between the metrical and the English System-
The display shows “UNIT”.
Press START to change between KM and MI.
Press STOP to confirm and leave the menu.
Die unit of measurement for speed and distance will be changed
correspondingly.
2) Read LCD and Controller Version
3) Reading the total running time in hours
4) Reading the total running performance (km or miles))
5) Switch buzzer on/off.
Simply press START to turn the buzzer on or off.
The display then changes in the program selection mode.
6) Adjust time for stand-by
Press START and adjust the switch off time by using the buttons
Speed (+) or Speed (-).
Pressing START again will confirm the value.
