HOW TO RECOGNISE A FAULT CODE
When a fault has occurred, the DishDrawer® will continuously beep every second.
The fault code will be displayed on the Electronic Display for prefinished and on the inside control panel
for integrated models.
Each fault code is shown in the chart below for prefinished and integrated models.
HOW TO ATTEND TO A FAULT CODE
1. Press the POWER button to remove the fault code.
2. If the fault code and continuous beeps cannot be removed by pressing the POWER button, turn the
power off at the power supply.
3. We recommend you check the chart below and correct the fault where possible.
4. After attending to the fault, turn the DishDrawer® on at the power supply.
5. If the fault code and continuous beeps remain, turn the water and power supply off to the
DishDrawer®.
6. When calling your Customer Care Centre or Authorised Service Centre advise them of the fault code
that has appeared on the DishDrawer®. This information will help us respond better to your requests.
If you have any questions about operating the product, please contact our Customer Care Centre on
00800-3810-4026.
Fault codes
18
FAULT CODES POSSIBLE CAUSES WHAT TO DO
Flood switch has been
activated.
Turn the water and power supply to the
DishDrawer® off and call your
Customer Care Centre or Authorised
Service Centre.
Motor problem.
Call your Customer Care Centre or
Authorised Service Centre.
Temperature sensor
failed.
Ensure water coming in through the inlet
hose is not hotter than 65°C. You may
need to install a tempering valve on your
water supply.
Faulty temperature
sensor or element.
Call your Customer Care Centre or
Authorised Service Centre.
Electronics malfunction.
Call your Customer Care Centre or
Authorised Service Centre.
Fill fault. - Turn the DishDrawer® water supply
on.
- Ensure the spray arm can rotate about
the centre, and if the DishDrawer® is
full of water, it will need to be emptied
manually.
- The water block has been tripped. Call
your Customer Care Centre or
Authorised Service Centre.
