Instructions for use
12
On/off of the Touch Control
1. On/off
2. Selection decimal points or association with the timer
3. Cooking area selection
4. Power increase
5. Power decrease
6. Timer display
7. Cooking point display
8. Selection decimal points or association with the timer
The electronic Touch Control is activated by means of the ON/OFF button and switches from the OFF
mode to the Standby mode.
To do so it is necessary to press the ON/OFF button for 1 second. A short Beep will be heard.
When in standby, “0” is displayed on the display of the cooking zone.
This display may go into background due to a residual heat or error signal.
If a cooking zone is activated during the standby time (10 sec.), the control switches over to the On mode.
If no introduction is made within the 10 sec., the control automatically switches to OFF with a short beep.
The electronics can be switched to the OFF mode at any time during the ON mode or the Standby mode by
pressing the ON/ OFF button. The Off function has priority when operating, meaning that the control
switches off even by activating several buttons at the same time.
Switching on a cooking zone
To begin using the product, turn on the cooking surface from the main O/I switch and use a suitable pan.
The touch control works on the principle of selection. The cooking point to be used must first be selected
before setting the power level with the “+/ -” keys. The display of a selected cooking point is brighter and
the decimal point of the display lights up.
Switching off a cooking zone
a) Selecting cooking level “0” of the desired cooking zone with the “-” button
b) Selecting the cooking area and then, simultaneously pressing the minus button and the cooking area
selection button.
c) Pressing the main O/I switch again turns the control off (all cooking points together) with a single
touch.
If the last cooking zone is switched off, the control switches to the OFF mode after 10 sec. if nothing else
is switched on.
All cooking zones are switched off immediately by pressing the ON/OFF button.
Cooking and power levels
The cooking and power levels of the cooking zones are shown on the display with 7 allotted segments. The
power of the cooking points can be adjusted to 9 levels and is displayed using numbers “1” to “9”; in
addition, the letter is “P” is displayed when the Booster function is activated.
Residual heat indicator
Indicates to the user that the glass is at a dangerous temperature if in contact with the area over the cooking
zone. The temperature is determined by means of a mathematical model and possible residual heat is
indicated by “H” on the corresponding 7 segment display.
Heating and cooling are calculated based on:
- The selected power level (from “0” to “9”);
- The relay activation time after the cooking zone has been switched off.
The corresponding display shows “H” until the zone temperature drops below the critical level (< 60 °C)
according to the mathematical model.
8.
8.
8.
