Bedienungsanleitung Koenic KAC 3232 CH (Seite 49 von 207) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch, Polnisch)

782555

Zoom out

Zoom in

Vorherige Seite

1/207

Nächste Seite

English

Fig. 13 Let them dry thoroughly before re-

attaching.

•Do not open the housing of the

product and do not insert any tools

into the air vents.

•This product does not contain any

parts that can be repaired or serviced

by the consumer. Contact a qualiﬁed

specialist to have it checked and

repaired as necessary.

Decommissioning

Fig. 14 Drain all water from the product and

dry it using the fan mode Fan for half

a day in a dry, warm room to prevent

mold. Switch the product into standby.

Unplug and ﬁx the power cord with the

cable tie to the back of the product.

Remove the exhaust hose assembly

from the product. Cover all drain outlets.

Remove the batteries from the remote

control. Close the cover of the wall

adaptor.

Transportation

Fig. 15 Wait at least 2 hours after moving the

device before operating the product

to avoid damages on the refrigerating

circuit.

Note:

The product is heavy. Therefore move the

product whenever possible by pushing or

pulling it, rolling on the castors. When lifting

is unavoidable, use the recessed handles

and lift with two people. Do not move the

product during operation.

Note:

If the water is not drained to an external

container and the upper drain outlet is closed

during automatic AUTO or cooling mode

COOL water is collected in an internal tank,

which must be drained when full. In this case

the product will emit an audible signal, while

the display on the control panel is showing

the protection code P1. The cooling process

will stop until the water is drained and the

product restarted, while the fan remains

running.

• Disconnect the product from the power

supply.

• Place the product with the lower drain

outlet above a suitable container or a drain.

• Remove the cover of the lower drain outlet.

• Attach the cover of the outlet again, when

all water is drained.

• Connect the plug to a suitable socket.

• The product is ready to be switched on.

Under some circumstances (e. g. high humidity)

the self-evaporation system may not be

sucient to handle the water and excessive

water is collected in the internal tank, which

must be drained as described above when full.

Cleaning & care

Fig. 11 Switch the product into Standby and

unplug in order to disconnect from the

mains.

Note:

Clean the product every two weeks. Clean

the outer surfaces of the product with a

damp cloth soaked in neutral detergent. Dry

it with a lint-free cloth. Do not use chemical,

alkaline, abrasive or other aggressive

detergents as they might be harmful to the

surfaces.

Fig. 12 Remove the air ﬁlters. Clean the air

ﬁlters in warm water (below 40 °C) and

neutral detergent.

IM_KAC3232_KAC3352_181220_V04_HR.indb 49 20/12/18 4:15 pm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Koenic KAC 3232 CH Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info