21
Set-Up Before Use
Telescopic pole connector assembly
Press down the side pins of the connector and insert it inside the main body. Turn the
connector in either direction until the pin is secured in the hole, as shown in the diagram.
Suction head assembly
Insert the suction head directly into the suction mouth of the pool vacuum until the side tabs
of the transparent case clip in the holes of the suction head’s pivot.
NOTE: To replace the brushes on the suction head, lift one end and pull the brush out to
make space for a new one.
WARNING! For vinyl liner and fibreglass pools, it is recommended to keep the brushes on
the suction head to avoid damaging the pool.
Telescopic pole assembly
Note: a V-clip is installed inside the pole connector to secure the telescopic pole (not
included) in position. Slide the telescopic pole onto the pole connector. Press on the side
pins of the connector and slide the telescopic pole further down until the pins of the
connector are secured inside the holes of the pole.
