Bedienungsanleitung Korg Kross 2 (Seite 108 von 152) (Englisch)

707348

108

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

Audio recorder

102

5. Press the MENU (Rec Control ) button or the

AUDIO REC (play/pause) button to start

recording. (AUDIO REC (play/pause) button: lit

red)

Note: The procedure here is for when Auto (Auto Rec

Start) is Off. As an alternative to the Rec Control button,

you can also initiate recording in other ways, such as by

playing the keyboard. (see “Specifying how recording

will start” on page 104)

6. Perform on the keyboard; the sound of the KROSS

will be recorded. You can also record the performance

of the Drum Track, the arpeggiator, and the step

sequencer.

Note: Even if you close the setup window, the recording

or standby condition of the recorder will be maintained.

7. To stop recording, press the PAGE+ (Stop/Reset )

button (AUDIO REC (play/pause) button:

unlit). When you stop, you’ll automatically return to

the time location where you started recording.

If you press the PAGE+ (Stop/Reset ) button while

stopped, you’ll return to the beginning of the audio

song.

If you press the AUDIO REC (play/pause)

button during recording, you’ll pause in the record-

standby state (AUDIO REC (play/pause)

button: blinking red).

If you press the MENU (Rec Control ) button during

recording, recording will end, playback will continue,

and the location will advance. To resume recording, press

the MENU (Rec Control ) button or the AUDIO REC

(play/pause) button.

Recording external audio input

If you want to record the sound of an external audio

inputsource, proceed as follows.

As an example, we will explain how to record from a mic.

1. Select a mic program.

Recording from a mic will be easy if you use a

programwhose input and effect settings have been set

upappropriately for a mic.

2. In the REALTIME CONTROLS section, use the

SELECT button to select AUDIO IN 1; then turn off

the SWITCH (ON/OFF) button, and turn the

VOLUME knob all the way to the left to lower the

volume.

Then connect a dynamic mic to the rear panel mic input

(MIC IN) jack.

You must turn the SWITCH (ON/OFF) button off and

use the VOLUME knob to minimize the volume before

you connect a mic or any other device. If you fail to

observe this precaution, your speaker system or other

equipment might be damaged.

Note: Also use the MIC IN jack if you’re connecting an

electric guitar. If you’re connecting a guitar equipped with

passive pickups, we recommend that you connect a preamp

or effect unit between your guitar and the KROSS.

3. In REALTIME CONTROLS, press the SWITCH

(ON/OFF) button to turn it on (lit).The mic input will

be enabled. Turn the VOLUME knob back toward its

original position to adjust the volume appropriately,

and play the keyboard or play back the audio

recorder while you input audio from the mic to check

the volume balance. If you want to adjust the mic

volume, use the SWITCH (ON/OFF) button to enable

the mic input, and then press FUNCTION

button?(QUICK SETTING) to open AUDIO IN-

QUICK SETTING-, and adjust the GAIN value.

Note: You can also adjust GAIN in the AUDIO IN 1 row

of the REALTIME CONTROLS section.

Note: Ideally, the level meter should be moving in

approximately 70% of its full range. If the input is

overloaded, the [MIC] indicator will be highlighted.

When you’ve finished adjusting the volume, save the

setting. (see “Global audio input settings (G-SET) and

individual settings” on page 22)

4. Specify the Direct Send setting. In this example, we

will mix and record the KROSS's performance, so

turn the setting off.

5. Adjust effect settings.

In the mic program, the Reverb Hall effect etc., which

applies reverberation to your vocal is assigned to Master

FX. If you want to turn off the effect, turn the MASTER

FX button off. To turn the effect off, use the SELECT

button to select the EFFECT row of REALTIME

CONTROLS, and turn off the SWITCH (MASTER FX)

button.

Use AUDIO IN1 - MFX/REVERB to set the amount of

effect. In REALTIME CONTROLS, use the SELECT

2a 2b

Level Meter [MIC] Gain

Audio IN ON/OFF

5a 5b

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Korg Kross 2 Seite 108

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Korg Kross 2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info