Bedienungsanleitung Korg VOX Continental (Seite 16 von 26) (Englisch)

707384

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

En-16

Detailed Functions 7. Touch controls

3) Compact

Turn the tone stops on or off.

For the tone stops, a type of instrument sound like the one

shown on the panel will play at the specified octave. Add these

tone stops to create your sound. The sounds and octaves are

listed below.

 BASS 16, STRINGS 16, FLUTE 8, OBOE 8, TRUMPET 8, STRINGS

8, FLUTE 4, PICCOLO 4, STRINGS 4

1 Press the PERC/MTB button to turn MTB off. (The button

will go dark.)

2 Touch one of the four LEDs on the lower side to turn them

on (the four LEDs on the bottom will light).

Touch one of the four LEDs on the top side to turn them on

(the four LEDs on the top will light).

The following diagram shows the pitches for each tone stop

when pressing C4 on the keyboard.

When MTB is on, the tone stop settings will be disabled, and

the Multi-Tone Booster will be applied to the sound.

1 Press the PERC/MTB button to turn MTB on. (The button

will light.)

2 Use the three touch sensors on the left side to turn MTB 16',

MTB 8', MTB 4' on or off.

The touch sensor on the right side (MTB Amount) adjusts

the MTB level, or the amount of the MTB effect.

KEY/LAYER

This controls the volume of the KEY/LAYER variation sound.

Each sensor controls the following parameters.

Refer to page 9 for how to use the touch sensors.

Note: The settings shown here are saved when a scene is

saved.

Amp EG

Adjusts the amp EG of the variation. This sets how the volume

will change over time.

(1) ATTACK

Sets whether the sound will reach full volume right after a note

is played, or whether the sound will gradually fade in.

(2) DECAY

Sets the decay of the sound following the attack time.

(3) RELEASE

Sets how long it takes for the sound to fade to silence after

note-off (releasing a key).

Filter

(4) CUTOFF

This cuts off the frequency range that you specify, such as the

high or low end of the sound.

For instance, you can use a low-pass filter to vary the

brightness of the sound. Making the normal value smaller will

produce a darker sound, and making the value larger will

produce a brighter sound.

Note: The filter differs for each variation.

(5) RESONANCE

This emphasizes the frequencies around the cutoff frequency.

When the value is 0, there is no emphasis, and frequencies

beyond the cutoff will simply diminish smoothly.

At medium settings, the resonance will make the sound more

nasal, or more extreme. At very high settings, the resonance

will sound like a whistling pitch.

OFF

Base note C4

MTB

Amount

16’ 8’4’

MTB ON

ONON

OFF

Base note

RESONANCE

PITCH LFO

LFO FREQ

CUTOFF

Frequency

HighLow

Level

LPF

Level

Time

Attack Time

Decay Time Release time

Attack Level

Start

Level

Sustain Level

note-on

note-o

Release Level

DECAY

ATTACK

RELEASE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Korg VOX Continental Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Korg VOX Continental

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info