Bedienungsanleitung Kress KG745 (Seite 16 von 156) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch)

819062

Zoom out

Zoom in

Vorherige Seite

1/156

Nächste Seite

TROUBLESHOOTING

The following table gives problems and actions that you can perform if your machine does not operate

correctly.

WARNING: Switch the machine off and remove the battery prior to any troubleshooting.



Problem Solution

1. Mower doesn’t run when

switch lever is activated. A. Check to make sure the button on switch housing is being completely

pushed.

B. Release Switch Lever to turn mower off. Turn mower over and check

that blade is free to turn. If not free, return to an authorized servicer. Blade

should turn freely.

C. Has battery been fully charged? Plug in charger and wait for green light

to come on.

2. Motor stops while mowing. A. Release Switch Lever to turn mower off. Turn mower over and check

that blade is free to turn. If not free, return to an authorized servicer. Blade

should turn freely.

B. Raise cutting height of wheels to highest position and start mower.

C. Has battery been fully charged? Plug in charger and wait for green light

to come on.

D. Avoid overloading the mower. Slow down the cutting pace by pushing

mower slower or raise the cut height. Or both.

3. Mower runs but cutting

performance is unsatisfactory,

or does not cut entire lawn.

A. Has battery been fully charged? Plug in charger and wait for green light

to come on.

B. Release Switch Lever to turn mower off. Turn mower over and check:

Blade for sharpness - Keep blade sharp. Deck and discharge chute for

clogging.

C. Wheel height adjustment may be set too low for grass condition. Raise

cutting height.

4. Mower is too hard to push. A. Raise cutting height to reduce deck drag on grass. Check each wheel for

free rotation.

5. Mower is abnormally noisy

and vibrates. A. Release Switch Lever to turn mower off. Turn mower on side and check

blade to ensure it has not been bent or damaged. If blade is damaged,

replace with a replacement blade. If the underside of the deck is damaged

return mower to an Authorized service center.

B. If there is no visible damage to the blade and the mower still vibrates:

Release Switch Lever to turn mower off, and remove the blade. Rotate

blade 180 degrees and retighten. If mower still vibrates, return the mower to

an authorized service center.

6. Battery charger LED’s not

on. A. Check plug connection.

B. Replace charger.

7. Battery charger LED does

not ip to green. A. Battery needs to be diagnosed. Take to authorized service center.

8. Mower not picking up

clippings with the Grass

Collection Bag.

A. Remove mulch plate when bagging.

B. Chute clogged. Release Switch Lever to turn mower off. Clear chute of

grass clippings.

C. Too much cut grass. Raise cutting height of wheels to shorten length of

the cut.

D. Bag full. Empty bag more often.

9. When mulching there are

clippings visible. A. Too much cut grass. Raise cutting height of wheels to shorten length of

the cut. Do not cut off more than 1/3 of total length.

B. Check blade for sharpness. Always keep blade sharp.

10. Low or diminished run-

time after many uses. A. Return to Authorized Service location - may need new battery.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kress KG745 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info